Advertisement
OWNERS
MANUAL
CAUTION:
Read Assembly
and Installation
Instructions
Carefully
The tempered safety glass
in your glass fireplace screen
has b e e n d e v e l o p e d t o g i v e
yo u many years of trouble
free service
A few rules for the proper
use a n d c a r e o f y o u r
G l a s s S c r e e n are necessary
for proper o p e r a t i o n a n d
s a t i s f a c t o r y service
Always use a grate for fires.
Place grate a minimum of 4
inches away from the glass.
When you have a large fire,
keep the doors open.
Do not allow burning coals or
logs to contact glass
Keep combustibles away from
front of screen.
Do not clean glass doors
while they are hot,
Read these instructions
completely before
proceeding.
Assembly
Installation
MR. FLAME™ Inc.
GLASS SCREEN
www.FireplaceDoorStore.com
GO Sales Inc.
3334 SE Teal Dr.
Gresham, OR 97080
1-877-663-7454
Advertisement
Table of Contents
Summary of Contents for Mr. Flame Glass Screen
- Page 1 OWNERS MR. FLAME™ Inc. MANUAL GLASS SCREEN CAUTION: Read Assembly and Installation Instructions Carefully The tempered safety glass in your glass fireplace screen has b e e n d e v e l o p e d t o g i v e...
- Page 2 This includes some mortars or sealants that may be used to install and seal enclosures and some paints used on fireplace faces. MR. FLAME Inc. ASSUMES NO RESPONSIBILITY FOR DAMAGES CAUSED TO GLASS ENCLOSURES CAUSED BY “ACID HEARTH"...
- Page 3 or otherwise locally dispersed, they should be retained in the closed container until all cinders have thoroughly cooled. CARE AND CLEANING: WARNING - DO NOT CLEAN GLASS WHEN HOT OR BREAKAGE MAY OCCUR. The glass in your glass enclosure is safety tempered. It may be broken by contact with burning wood or spilled liquids, by cleanin glass with a wet cloth or by too large a fire.
- Page 4 It also makes no warranty as to maximum temperature and stresses which may cause discoloration of the finish. MR. FLAME™ Inc. shall not be liable for consequential or indirect damages which are caused by defects in its product, by its repair or replacement.
- Page 5 MOUNTING PARTS REMOVE ALL PARTS FROM HARDWARE KITS AND THE CARTON. TO ENSURE YOU HAVE ALL THE NECESSARY PARTS, MATCH UP PIECES WITH THE PARTS LISTED ABOVE.
- Page 6 INSTALLATION INSTRUCTIONS 1. Before installing enclosure, be sure fire is out and fireplace is cool and clean. Read "Ash Disposal" (page 2) ALWAYS lift enclosure by sides, NEVER top bar. Remove enclosure from box and lean upright against the wall. Remove and save hardware kit from the box.
Need help?
Do you have a question about the Glass Screen and is the answer not in the manual?
Questions and answers