GE Profile PFWS4605 Owner's Manual page 11

About the washer features.
Adjustment
Rails
For HE powder detergent remove
the Detergent selection insert and
add powder here
For HE liquid detergent that is non-
concentrated, place the insert in the "1X"
position
The Detergent Compartment
Only use high-efficiency detergent
in this washer. DO NOT fill high-efficiency
detergent over the MAX line. Use
detergent manufacturer's recommended
amount.
Powder Detergent – Remove the Detergent
selection insert and place it in a safe
location outside of the washer. Follow the
detergent manufacturer's instructions
when measuring the amount of powder to
use.
Liquid Detergent – Locate the
concentration of your detergent on the
bottle. Place the Detergent selection insert
in the corresponding location depending on
the concentration.
For HE 2X liquid detergent, place
the insert in the "2X" position
The Liquid Bleach Compartment
If desired, measure out the recommended
amount of liquid bleach, not to exceed
1/3 cup (80 ml) and pour into the center
compartment labeled "LIQUID BLEACH"
marked with this symbol
It is recommended to use High-Efficiency (HE)
bleach in this front-load washer.
The Fabric Softener Compartment
If desired, pour the recommended amount
of liquid fabric softener into the compartment
labeled "FABRIC SOFTENER."
Use only liquid fabric softener in the dispenser.
Dilute with water to the maximum fill line.
Move the insert by pulling it up and replace
it by sliding it down between two detergent
compartment rails. Make sure to push the
insert to the bottom of the compartment
so that it is flush to the bottom of the
compartment. It is not an issue if the
detergent leaks past the insert to the back
of the compartment.
Detergent usage may need to be adjusted
for water temperature, water hardness,
size and soil level of the load. Avoid using
too much detergent in your washer as it
can lead to oversudsing, detergent residue
being left on the clothes, and could extend
wash times.
Do not put clumped detergent in the
dispenser. Clumped detergent can cause a
leak.
For HE 3X liquid detergent, place
the insert in the "3X" position
Do not exceed the maximum fill line. Overfilling
can cause early dispensing of the bleach which
could result in damaged clothes.
NOTE: Do not use powdered bleach in the
.
dispenser.
Do not exceed the maximum fill line. Overfilling
can cause early dispensing of the fabric
softener, which could stain clothes.
NOTE: Do not pour fabric softener directly
on the wash load.
GEAppliances.com
11