Honda Automobiles 2008 Civic Si Coupe Owner's Manual page 248

Main Menu
BULB
2. Remove the bulb by turning it one-
quarter turn counterclockwise.
3. Remove the electrical connector
from the bulb by pushing on the
tab and pulling the connector
down.
Table Of Contents
4. Insert the new bulb into the hole,
and turn it one-quarter turn
clockwise to lock it in place.
5. Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
6. Turn on the headlights to test the
new bulb.
7. If you replaced a headlight bulb on
the driver's side, reinstall the
TAB
engine coolant reserve tank.
2008 Civic Sedan
Low Beam Headlight
HOLDING CLIP
1. To change the bulb on the driver's
side, start the engine, turn the
steering wheel all the way to the
right, then turn off the engine. To
change the bulb on the passenger's
side, turn the steering wheel to the
left.
2. Use a flat-tipped screwdriver to
remove the two holding clips from
the inner fender, and pull the inner
fender cover back.
Lights
CONTINUED
245