Names And Functions Of Remote Control Unit - Hitachi RAK-50N6 Instruction Manual

NAMES AND FUNCTIONS OF REMOTE CONTROL UNIT

REMOTE CONTROLLER
This controls the operation of the indoor unit. The range of control is about 7 meters. If indoor lighting
is controlled electronically, the range of control may be shorter.
This unit can be fixed on a wall using the fixture provided. Before fixing it, make sure the indoor unit can
be controlled from the remote controller.
CIRCULATION / START
DEHUMIDIFY / START
COOLING / START
FAN
FAN SPEED
SILENT
LOW
MED
HI
SLEEP TIMER
STOP
TIMER SELECTOR
ON TIMER
AUTO SWING
SUPER SILENT
Transmission sign
●
The transmission sign blinks when a signal is sent.
Display
●
This indicates the room temperature selected, timer status, function
and intensity of circulation selected.
CIRCULATION button
●
Use this button to set air circulation in the room or start operation.
DEHUMIDIFYING button
●
Use this button to dehumidify the room or start operation.
COOLING button
●
Use this button to set cooling mode in the room or start operation.
RESET button
●
SPEED COOL button
●
Use this button to deliver faster and more comfortable air-
conditioning.TO
STOP button
●
Press this button to stop operation only.
SUPER SILENT button
●
Use this button to set silent condition.
FAN SPEED selector
●
This determines the fan speed. Every time you press this button, the
intensity of circulation will change from
to (LOW) to (SILENT).
AUTO SWING button
●
Controls the angle of the horizontal air deflector.
TEMPERATURE button
●
Use this button to raise or lower the temperature setting. (Keep
pressed, and the value will change more quickly.)
SLEEP button
●
Use this button to set the sleep timer.
ON-TIMER button
●
Precautions for Use
Do not put the remote controller in the following places.
●
In direct sunlight.
●
In the vicinity of a heater.
●
Handle the remote controller carefully. Do not drop it on the
●
floor, and protect it from water.
Once the outdoor unit stops, it will not restart for about 3 minutes
●
(unless you turn the power switch off and on or unplug the
power cord and plug it in again).
This is to protect the device and does not indicate a failure.
– 6 –
A
(AUTO) to
Select to turn ON time.
(HI) to (MED)