Table of Contents
Advertisement
USING WITH THE FACE MASK
Use
8
1
Press the »
« button to switch
on the appliance.
– The appliance starts at the
lowest temperature level
which takes 10 minutes to
reach as long as the timer set-
ting has not been changed.
2
Select the required temperature
level with »
high and PU = pulse higher and
lower temperatures).
Note
The LO, HI and PU (»pulse«) set-
7
tings are based on the original
duration of 10 minutes, as long
as the timer setting has not been
changed.
3
Select the timer setting with »
(10 up to maximum of
30 minutes).
Note
Once the set time has elapsed,
7
a signal tone is emitted three
times.
8
4
Press »
« to switch off the appli-
ance after use.
5
Disconnect the power cord from
the wall socket.
22 ENGLISH
« (LO = low, HI =
Important note
It is advisable to use the LO =
7
low temperature level. Too hot
steam could cause injury to
your face.
Do not hold your face too near
7
to the mask.
We recommend using the
7
appliance for not longer than
20 minutes per day and not
more than two or three times a
week.
You can stop the treatment at
7
any time, by pressing »
switch off.
Rinse your face with cold water
7
at the end of each session. Then
you can begin the cosmetic
treatment.
«
Always disconnect the power
7
plug after use. Leave the appli-
ance to cool down for 10 to
15 minutes.
Once it has cooled down,
7
remove the face mask from the
basic appliance (anti-clockwise -
). Pour the remaining water in
the container down the drain.
------------------------------------------------
8
« to
Advertisement
Table of Contents
