Advertisement

Quick Links

Dimp13292-Shower inst aX3
5/5/04
2:08 pm

SERVICE POLICY/GUARANTEE

In the event of you needing to contact the Dimplex Customer Service Department,
the following procedure should be followed:-
Before telephoning the Dimplex Customer Service Department you should
1
ensure that you have the model number, power rating, serial number and
date of purchase.
The Dimplex Customer Service Department will be able to inform you whether
2
the fault can be rectified by the provision of a replacement part or an on site
visit by a Qualified Service Engineer.
If a service call is booked, you or a representative must be present during the
3
Engineers visit.
A charge will be made where a call under the terms of the guarantee has
4
been booked and a failure was not product related, or an engineer arrives
and is not able to gain access.
If the product is no longer covered by the Guarantee, a charge will be made
5
for the site visit and for any parts supplied.
Customer Services Tel 0870 240 9402
GUARANTEE
Glen Dimplex Limited guarantee this product for a period of two years, from date of purchase,
against mechanical and electrical defects arising from faulty materials or manufacturing defects,
providing the product has been installed by a competent person in accordance with the
fitting instructions.
Glen Dimplex Limited undertake to repair or replace, at their discretion, without charge,
provided the product has been properly maintained and operated in accordance with the
operating instructions. Any component found to be defective during this period, as the result
of misuse or damage, or the effects of scaling, will not be covered by this guarantee.
This product must not be modified, repaired or taken apart except by a person authorised by
Glen Dimplex Limited.
This Guarantee is only valid within the United Kingdom and does not cover product used commercially.
This Guarantee does not affect your statutory rights.
Glen Dimplex UK Limited, Millbrook House, Grange Drive, Hedge End, Southampton SO30 2DF.
Tel 0870 077 7117 Fax 0870 727 0109
Page 1
Shower User Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the aX3 and is the answer not in the manual?

Questions and answers

Summary of Contents for Dimplex aX3

  • Page 1 GUARANTEE Shower User Guide Glen Dimplex Limited guarantee this product for a period of two years, from date of purchase, against mechanical and electrical defects arising from faulty materials or manufacturing defects, providing the product has been installed by a competent person in accordance with the fitting instructions.
  • Page 2 Dimp13292-Shower inst aX3 5/5/04 2:08 pm Page 3 DIMENSIONS UNPACKING AND IMPORTANT NOTICES / INSTALLATION SECTION 1 5) Do not use Plumbers jointing compound. Unpacking and important notices Use of plumbers jointing compounds invalidates the guarantee. Contents 1 x Shower Unit...
  • Page 3 Dimp13292-Shower inst aX3 5/5/04 2:08 pm Page 5 INSTALLATION INSTALLATION Planning the installation General Plumbing 4) Carefully drill the holes using a 5.5mm masonry drill (note when drilling though 1) Fit an isolating valve to the mains tiles first use a glass or tile drill bit of 6mm...
  • Page 4 Dimp13292-Shower inst aX3 5/5/04 2:08 pm Page 7 INSTALLATION INSTALLATION / FINAL ASSEMBLY AND COMMISSIONING Assembly The cable should be routed to the shower 2) Fit the flexible hose to the shower unit unit from either the top, bottom or back and remove the showerhead.
  • Page 5 Dimp13292-Shower inst aX3 5/5/04 2:08 pm Page 9 FINAL ASSEMBLY AND COMMISSIONING / OPERATION OPERATION 1) Make sure that the power selector at 9) Turn the bottom temperature control blocking the holes – see Section 5 the top of the shower is in the cold knob clockwise for hotter water and ‘Looking after your shower’.
  • Page 6 Clean the showerhead, and restart the Looking after your shower shower. Select a heat setting, if no hot water is produced call the Dimplex Service Centre. Before calling our customer service The showerhead should be cleaned department please use the table to Power indicator is The power setting is on cold.

This manual is also suitable for:

Aquabatix x3

Table of Contents