Service Notes - Fender 215 PRO Service Manual

Input Assembly removal is required for lamp re-
placement and is accomplished by following these
steps:
1. Remove the four screws from the input panel
corners.
2. Pull the panel out at the top until the L-pad is
clear of the mounting plate, then pull upward on
the assembly.
PCB EXCHANGE POLICY
Parts marked with a single asterisk (
Lists are not field replaceable. If a failure due to
one of these components is detected, please con-
tact the FMIC Customer Service Department to
order the complete PCB Assembly.

SERVICE NOTES

) in the Part
*
(This is the model name for warranty claims)
3. Use a small screwdriver or other tool to remove
the blown lamp, which is visible through a cut-
out in the circuit board.
4. Remove the spare lamp stowed on the side of
the circuit board and install it where the blown
lamp was removed.
5. Install the input assembly in the reverse order
of removal.
4
215 PRO