Table of Contents
Advertisement
High Frequency Driver replacement continued:
-
Push down
5
The positive (solid blue) and negative
(blue and black) cables are still
attached to the high frequency driver
terminals. Remove the cables from their
terminals simply by pushing down on the
terminal and pulling out the cable.
6
Four nuts and eight washers may be
removed from the driver using the
8mm open end wrench. Turn counter-
clockwise to loosen and remove,
clockwise to tighten. The other pair is in
the same place on the other side of the
horn assembly.
+
7
Keep the four nuts, four fl at washers, and
four locking washers in a safe place.
8
Lift the horn up as the nuts are loosened.
It cannot be removed otherwise. Notice
that the fl at washer is on the bottom,
followed by the locking washer, and
fi nally the nut.
locking
nut
washer
fl at washer
8
Advertisement
Table of Contents
