Advertisement
PRE-OPERATING INSTRUCTIONS
1. Carefully remove your heater from the box. (please save
the carton for off-season storage).
2. Make sure the unit is in the OFF position before plugging
the heater into the outlet.
3. Place heater on firm level surface.
4. Avoid overloading your circuit by not using other high
wattage appliances in the same outlet. At 1500 Watts,
this unit draws 12.5 Amps.
ASSEMBLY INSTRUCTIONS
There are 4 casters and 4 screws provided within the packaging
that you will need to assemble the base.
Note: Casters are not necessary for the unit to run
properly. If you wish to install without castors
skip to number 5.
1. Carefully remove the base and 4 castors from the box.
2. Turn the base upside down and screw the castors into the
4 corresponding holes.
3. Place the base right side up on a firm level surface.
4. Carefully remove the flat panel heater from the box.
5. With the grill facing you, place the tabs at the bottom
of the heater directly into the corresponding holes in
the base and slide the heater to the left. This will lock
the unit onto the base.
6. To remove the heater from the base, press down on the
lock switch located on the right side of the base and slide
the heater to the right and lift up.
WALL MOUNTING INSTRUCTIONS
This unit has the unique feature of using the base as the wall
mount bracket.
A. HEPA FILTER
Figure 3
B. CARBON FILTER
C. HANG TABS
D
D. AIR INLET GRILL
E. FILTERED AIR
OUTLET
F.
SPEED CONTROL
KNOB
G. FILTER LIFE
INDICATOR
H. RESET
I.
POWER CORD
(not shown)
OPERATING INSTRUCTIONS
1. For heater operation, please set the Thermostat
all the way to HI. (See fig. #1)
2. Turn the Selector Control to desired heat setting
(LO for 1000W or HI for 1500W).
3. The Power Light will remain lit during operation.
SETTING THE THERMOSTAT
1. You need to set thermostat on HI to start heater
(See fig. #1). Allow heater to operate and warm
up the room.
2. When the desired temperature/comfort level is reached,
lower the thermostat setting until the heater stops operating.
3. The control will now automatically maintain the pre-set
temperature level by turning the heater ON and OFF. The
Temperature Range Display can be used as guidance, but
will not provide exact measurement.
Note: It is normal for the heater to cycle ON and
OFF as it maintains the preset temperature.
To prevent the unit from cycling, you need to raise
the thermostat setting.
CLEANING/MAINTENANCE
During Season Care:
1. Always unplug the heater before cleaning.
2. Clean the unit with a soft cloth moistened with a mild
soap solution.
3. NEVER use abrasive or flammable solvents to clean the unit.
4. After cleaning, be sure to completely dry the unit with
a cloth or towel.
After Season Care:
1. Store heater in a cool, dry location.
2. Holmes recommends that you store the unit in its
original carton.
TROUBLESHOOTING
If your heater fails to operate:
· UNPLUG THE UNIT
· Make sure the electrical outlet or circuit breaker is working.
· Check for obstructions. If you find an obstruction turn the
heater OFF, and unplug the unit. Carefully remove the
E
obstruction and follow the reset instructions.
· The temperature may be set too low. Turn the thermostat
F
knob clockwise until the heater restarts.
G
· Make sure selector is in LO or HI setting.
H
Please DO NOT attempt to open or repair the heater. Please see
the Warranty for Service Instructions.
I
Page 3
Advertisement
