Krell Industries CIPHER Owner Reference Manual page 29

Using the Repeat Key (22)
Press the repeat key once to repeat the current track. The front panel display (19)
reads
REPEAT SINGLE
panel display reads
function.
Using the Repeat A/B Key (23)
To create an A/B loop, start by playing a track. When you hear the part that you
want as the beginning of the loop, press A/B to insert the start position. Press A/B
again to insert the finish position. A/B playback will automatically begin and will
continue indefinitely. To delete, press A/B again, or press the stop button (5) or key.
Using the Front Panel Display (19)
The front panel display shows the disc type, the elapsed time of the track, and the
feature that has been selected, for example:
display button (21) or key to show track time remaining, disc elapsed time, or disc
time remaining. Press the dim button (20) or key to reduce the brightness of the
display.
Using the 12 V Trigger (31)
This function allows you to turn other components on or off, or to and from stand-
by, from the CIPHER. When the CIPHER is switched between stand-by and the
operational mode, the 12 V trigger sends a signal from the 12 VDC Out that will
switch other components, allowing whole systems or parts of systems to be easily
coordinated.
The 12 VDC input allows you to turn the CIPHER on or off, or to and from stand-
by, from other components.
Note
When the component is in the operational mode, the 12 VDC Out provides 12 V of DC out-
put. When the component is in the stand-by mode or off, the DC output is 0 V. The 12 VDC
output current is limited to 30 mA. Consult the owner's reference of the components used
in a custom installation to take full advantage of the remote capability of the CIPHER.
Using the RS-232 Port (32)
For more information on using the RS-232 communications port, see the Cipher
developer's reference.
. Press the repeat key twice to repeat the whole disc. The front
. Press the repeat key a third time to cancel this
REPEAT ALL
29
or
REPEAT ALL REPEAT SINGLE
. Press the