JVC Exad KD-AVX77 Instructions Manual page 78

When using the optional stay
Dashboard
Removing the unit
Before removing the unit, release the rear section.
A
Connecting the parking brake lead
Connect the parking brake lead to the parking brake system built in the car.
Parking brake
B
Connecting the reverse gear signal lead (for rear view camera) (REVERSE GEAR SIGNAL)
Locate the reverse lamp lead in the trunk.
Reverse lamp lead
C
Connecting the microphone (only for KD-AVX77)
1
N
Microphone
Stay (option)
Fire wall
Screw (option)
30˚
Install the unit at an angle of less than 30˚.
Parking brake switch (inside the car)
Reverse lamps
2
O
Microphone clip
Secure the microphone cord using cord cramps
(not supplied) if necessary.
When installing the unit without using the sleeve
In a car having the "Required space for installation" (see page 1), first remove the car radio and install the
unit in its place.
3
Flat type screws—M5 x 8 mm *
* 3
Bracket
Bracket * 3
Note:
• When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws.
If longer screws are used, they could damage the unit.
• Tighten the screws firmly to prevent the unit from falling off.
Insert the two handles, then pull them as
illustrated so that the unit can be removed.
Extension lead (not supplied)
To reverse lamp
Crimp connector
(not supplied)
or
P
Microphone holder
2
3
* Not included for this unit.
Flat type screws—M5 x 8 mm
Parking brake lead (light green)
To metallic body or chassis of the car
Purple with white stripe
To car battery
Reverse lamp lead
Adhesive tape
3
*