Conair Massaging FOOT spa Instruction Booklet

When using an electrical appliance, basic precautions should always be followed,
including the following: Read and follow all safety instructions before using this appliance.
DANGER
1) Always unplug this appliance from the electrical outlet immediately after using and before
cleaning.
2) Do not reach for an appliance that has fallen into water. Unplug immediately.
3) Do not use while bathing or in a shower.
4) Do not place or store appliance where it can fall or be pulled into a tub or sink. Do not place
or drop into water or other liquid.
WARNING
1) An appliance should never be left unattended when plugged in. Unplug from outlet when
not in use, and before putting on or taking off parts.
2) Close supervision is necessary when this appliance is used by, on, or near children, or
persons with disabilities or incapacitated persons.
3) Use this appliance only for its intended use as described in this manual.
Do not use attachments not recommended by Conair.
4) Never operate this appliance if it has a damaged cord or plug, if it is not working properly,
or if it has been dropped or damaged, or dropped into water. Return the appliance to a
Conair Service Centre for examination and repair.
5) Do not carry this appliance by supply cord or use cord as a handle.
6) Keep the cord away from heated surfaces.
7) Never operate the appliance with the air openings blocked. Keep the air openings
free of lint, hair and other particles.
8) Never drop or insert any object into any opening.
9) To disconnect, turn all controls to the off position, then remove plug from the outlet.
10) Do not use outdoors.
11) Do not operate where aerosol (spray) products are being used or where oxygen is being
administered.
12) Do not attempt to plug or unplug unit while feet are in the water.
13) Do not stand on or in the foot bath. Use only while seated. Place feet in bath and
remove feet from bath only while in a seated position.
14) Never operate on a soft surface, such as a bed or couch, where air openings may be
blocked.
IMPORTANT SAFETY
INSTRUCTIONS
To reduce the risk of electric shock:
To reduce the risk of burns, fire, electric shock, or injury to persons: