Advertisement
ASSEMBLY INSTRUCTIONS
For the HAOF720, your product comes fully assembled.
Please skip to the Operating Instructions.
For all other fans, please continue below with the
Pre-Assembly Instructions.
Pre-Assembly
Step 1: Remove your fan from inside the box, being careful not to
discard any of the items that are needed for assembly.
Base Assembly
Step 1: Insert the body into the base.
Step 2: Tighten the base nut onto the bottom of the body.
Fan Head Assembly
Step 1: Remove protective plastic sleeve from the motor shaft.
Step 2: Position the rear grill over the motor shaft, making sure the
circular opening in the center of the rear grill fits over the
prongs on the rear housing. Please make sure the rear grill
fits securely against the motor housing.
Step 3: Secure the rear grill in its place using the rear grill-mounting
nut. Turn this nut clockwise and tighten firmly.
Step 4: FOR HAOF920
Slide the fan blade firmly onto the motor shaft. Make sure
that the blade is pushed onto the motor shaft as far as
possible before putting on the front grill.
FOR HAOF1220, 1620
Align "D" shaped shaft with the "D" shaped hole in the center
of the blade. Slide the fan blade, with the hollowed interior of
the blade facing towards the rear of the grill firmly onto the
motor shaft, until motor shaft protrudes from the front of the
fan blade. Secure the fan blade onto the motor shaft by firmly
tightening the fan blade nut.
NOTE: TURN THE FAN BLADE NUT COUNTER-CLOCKWISE
Step 5: Center the front grill by aligning the Holmes logo on the grill
hub so it is horizontal and parallel with the floor, making
sure that the grill clips are in the open position. Closing the
clips will attach the front grill to the rear grill.
OPERATING INSTRUCTIONS
Step 1: Set the fan base on a dry, level surface.
Step 2: Please make sure the Speed Control Knob is in the "O" Off
position. Plug the cord into any standard 120-volt A/C
outlet.
Step 3: The SPEED is adjusted by moving the knob left or right to
the desired setting.
Step 4: The OSCILLATION control knob is located on the top of the
fan motor housing. To start oscillation, push control knob
down. To stop oscillation, pull control knob up.
ADJUSTMENT INSTRUCTIONS
Tilt Adjustment
To change the tilting angle of the fan head, move the fan head to
the desired angle.
CLEANING/MAINTENANCE
Follow these instructions to correctly and safely care for your
Holmes table fan. Please remember:
• Always unplug the fan before cleaning or disassembling.
• Do not allow water to drip on or into the fan motor housing.
• Do not use any of the following as a cleaner: gasoline, thinner,
or benzine
(See instructions for fan head assembly)
Step 1: To access the fan blade, remove the front grill and the
fan blade nut.
Step 2: Clean the fan blade, both front and rear grills with a soft
cloth moistened with a mild soap solution.
Step 3: Replace blade, tighten the fan blade nut, and securely
fasten the front grill.
Fan Head and Base Cleaning
Using a soft, moist cloth, with or without a mild soap solution,
carefully clean the fan base and head. Please use caution around
the motor
housing area. Do not allow the motor or other electrical compo-
nents to be exposed to water.
Advertisement
