Internal Functions - Yamaha KX88 Authorized Product Manual

TS1,2
These switches each have two functions, so you must
assign two controller codes to them.
In PLAY mode, if TS is pressed while the LED is off, the
first function will be sent. If it is pressed when the LED
is on, the second function will be sent. When you press
TS1 or 2 in CA mode, the upper readout will show T1
for about one second. Then, the upper and lower
readouts will show the first and second controller codes
currently assigned to that switch. Enter the new con-
troller codes using bank B program select switches 1-16.
(0-F)
MS1-5, FS1, 2
Select these controllers by pressing the controller itself.
The upper readout will indicate the selected controller.
Enter the new controller code using the bank B program
select switches.
MIDI CH
MIDI CH
The MIDI channels of banks A and B will be displayed.
Select the bank you want to change by pressing bank
switch A or B, and select the new channel with bank B
program select switches 1-16.
TRANSPOSE
TRANSPOSE
You may transpose banks A and B independently. The
current transpose point for banks A and B will be shown
in the readouts. Select the bank you want to transpose
by pressing bank switch A or B, and press a key at the
desired transpose point. (A decimal point indicates a #.)
BANK 2/8
B A N K 2 / 8
This changes the voice program selection method for
play mode. The upper readout will show BN . Each
time you press this switch, the lower readout will alter-
nate between 2 and 8.
S A V E
SAVE
All the settings and assignments made in CA mode may
be stored in one of 16 code memories. Use bank B pro-
gram select switches 1-16 to choose the code memory
you want to save the current settings in. The selected
number will blink in the lower readout, and when you
press that same number again, all current settings will be
stored in that code memory as follows.
All controller code assignments and bank A/B ena-
ble/disabble settings made in CA mode.
Transpose points A and B
Bank select 2/8
Split point
Bank A and B channel numbers
L O A D
L O A D
Use this to recall the setting you saved in 7.
When you press this switch, the upper readout will show
Use bank B program select switches to select the
L0 .
desired code memory.

INTERNAL FUNCTIONS

Controller codes 00-3F have been preset with various func-
tions. When in PLAY mode you operate a controller that
has been assigned one of these controller codes, this is what
happens.
00 SINGLE
The keyboard mode changes to SINGLE, and sends
key on/off information on either bank A or B.
01 DUAL
The keyboard mode changes to DUAL, and sends key
on/off information on both banks A and B.
02 SPLIT/SPLIT POINT
The keyboard mode changes to SPLIT, and sends key
on/off information from the lower part of the key-
board on bank A, and the upper part on bank B.
If this is activated While Already In Split Mode, the
upper readout will display SP, and the lower will dis-
play the current split point. The next key you touch
will be the new split point. If you do not want to
change the split point, press MODE.
03 SWAP CHANNEL
This interchanges the MIDI channel numbers of banks
A and B. The voice program numbers in the readouts
will change places.
- 1 0 -