Table of Contents
Advertisement
Adjusting Projected Images
d
Using the [
], [
], [ ], and [ ] buttons on the remote control,
or the [
], [
], [
], and [
w
v
a
the corner to correct, and then press the [
] buttons on the control panel, select
b
] button.
e
Using the [
], [
], [ ], and [ ] buttons on the remote control,
or the [
], [
], [
], and [
w
v
a
the position of the corner.
When you press the [
] button, the screen shown in step 4 that
allows you to select the area to be corrected is displayed.
If the message "Cannot adjust any further." is displayed while
adjusting, you cannot adjust the shape any further in the direction
indicated by the gray triangle.
f
Repeat procedures 4 and 5 as needed to adjust any remaining
corners.
g
When you are done, press the [Esc] button to exit the correction
menu.
Because Keystone was changed to Quick Corner, the corner
selection screen shown in step 4 is displayed the next time you press
the [
] or [
] button on the control panel. Change Keystone to
w
v
H/V-Keystone if you want to perform horizontal and vertical
correction using the [
] or [
w
Settings - Keystone - H/V-Keystone
s
] buttons on the control panel, correct
b
] button on the control panel.
v
p.90
39
Advertisement
Table of Contents
