Tannoy Proto-J Reference Manual page 15

6.0 SERVICING
6.1 Cabinet finish
To remove marks and scuffs use a soft brush. If necessary, a little warm water and detergent can be
used but under no circumstances use a solvent or abrasive cleaner.
6.2 Driver removal
Lay the cabinet on its back. Remove the six hexagonal screws and set aside. Ease the driver from
the front of the cabinet taking care not to mark the front surface. Remove the driver, note the polarity
of the internal connections and disconnect the internal wiring. Take care not to damage the moving
parts of the LF driver. To refit the driver, connect the cables from the crossover to the LF terminals.
Fit the driver into the mounting hole, making sure that the internal connecting cables are not trapped
or able to touch the LF cone. Fasten the screws finger tight and then progressively tighten them
down with the appropriate Allen key.
Repeat the same procedure for the HF driver.
6.3 Crossover
The crossover is mounted on the rear of the terminal panel. To inspect it, remove the panel by
releasing the hexagonal screws. Take care to avoid undue stress on the cables and components.
To remove the crossover completely the cables must be disconnected from the drive unit. Please
proceed as above to remove the drive unit.
6.4 List of spare parts.
PART NUMBER
5DR61084
5DR53100
7.0 WARRANTY
No maintenance of the Proto-J monitor is necessary.
All components are guaranteed for a period of five years from the date of manufacture, subject to
the absence of, or evidence of, misuse, overload or accidental damage.
For further information please contact your dealer or the distributor in your country.
If you cannot locate your distributor please contact:
Customer Services
Tannoy North America Inc.
335 Gage Ave., Suite #1 Kitchener, On Canada N2M 2C8
Telephone: (519) 745-1158 Fax: (519) 745-2364
E-mail: inquiries@tannoyna.com Internet: http://www.tannoy.com
DO NOT SHIP ANY PRODUCT TO TANNOY WITHOUT PREVIOUS AUTHORIZATION.
This warranty in no way affects your statutory rights.
DESCRIPTION
Driver kit – LF
HF unit