Sharp KB-3401LS Supplemental Service Manual page 29

OVEN BAKE ELEMENT REMOVAL
. Disconnect the power supply cord.
2. Refer to the disassembly instructions as previously stated.
3. Disconnect the wires by removing (2) nuts from element (Fig. O-5)
4. Remove the (2) screws holding the element from inside the oven (Fig. O-6).
5. Pull the Element into the oven.
6. Proceed in reverse to reinstall the Bake Element.
Fig. O-5
OVEN BROIL ELEMENT REMOVAL
. Disconnect the power supply cord.
2. Refer to the disassembly instructions as previously stated.
3. Disconnect the wires by removing (2) nuts from element (Fig. O-7)
4. Remove the (2) screws holding the element from inside the oven (Fig. O-8).
5. Pull the Element into the oven.
6. Proceed in reverse to reinstall the Broil Element.
Fig. O-7
THERMISTOR REMOVAL
. Disconnect the power supply cord.
2. Refer to the disassembly instructions as previously stated.
3. Unhook rear Molex wiring from Thermistor (Fig. O-9)
4. Remove tape from Thermistor rear hole.
5. Remove the (2) screws holding the Thermistor from inside the oven (Fig. O-10).
6. Pull the Thermistor into the oven.
7. Proceed in reverse to reinstall the Thermistor.
Fig. O-9
Fig. O-6
Fig. O-8
Fig. O-10
29
KB-3401LS
KB-3401LK
KB-3401LW