PART INDENTIFICATION Handle cover Handle Filter maintenance sign Clamp Dust compartment Front cover Furniture guard HOW TO OPERATE TO INSTALL THE HANDLE 1. Insert the handle into the opening on the top of the cleaner and ) tighten screw 2) Fix the handle cover to handle firmly. When you take it off, insert a screwdriver (straight type) in the side hole of handle cover and detach it.
ON-OFF SWITCH (Fig. 3) Turn cleaner on or off by pushing downward on the power switch CORD STORAGE AND RELEASE 1. To store the cord, turn the upper cord storage hook to the upward position, and wrap the cord around the hooks.
Page 4
AUTOMATIC HEIGHT CONTROL The HITACHI vacuum cleaner has an automatic height control, which adjusts the nozzle to the proper height of any carpet pile. DUST COMPARTMENT OPERATION When the orange sign appears continuously in the window, empty the dust compartment.
HOW TO USE TOOLS Use the tools you require for cleaning hard floors, fabrics and curtains etc. 1. Ensure the cleaner is in the upright position. 2. Hold the dusting brush shown in Fig.10, and disconnect the dusting brush from the extension pipe.
HOW TO CLEAR A BLOCKAGE If your cleaner is used when the dust compartment is full or if any blockages are sucked in by accident, the air ducts may become clogged. If this occurs, remove the blockages or obstructions from the air ducts as follows. CAUTION: Be sure to disconnect the plug from the electrical outlet.
How to empty the dust compartment 1) Empty the dust compartment before dust reaches the max line. 2) If you continue using the cleaner, the suction power will be diminished due to dust clogging the filter. 3) Please remove the dust. NOTE: Switch off the power and remove the mains plug from the socket before emptying the dust compartment.
Page 8
*Filters in dust case (Washable) (Maintenance once a month) 1) Remove the dust compartment and empty out the dust. 2) -1. Press the button with thumb. -2. Remove the cyclone case by pushing the button with two fingers (the forefinger and the middle finger). -3.
SERVICING AND REPAIRS CAUTION: Be sure to disconnect the plug from the electrical outlet before replacing the belt or the rotary brush. *HOW TO REPLACE THE BELT The drive belt should be checked regularly to ensure that it is in good condition. If it is stretched, cracked or cut, it should be replaced.
Page 10
Remove any threads and long strings entwined round the rotary brush after cutting through. G Only Hitachi special composition carbon brushes must be used in this cleaner. Replacement of the brushes must be carried out by an Hitachi dealer/service center.
Page 11
IMPORTANT The mains lead on this equipment is supplied with a moulded plug incorporating a fuse, the value of which is indicated on the pin face of the plug. Should the fuse need to be replaced, an ASTA or BSI approved BS 1362 fuse must be used of the same rating.
Page 12
Tel: 04 72 14 29 70 Fax: 04 72 14 29 99 Email: france.consommateur@hitachi-eu.com IBEUROPE HEL H&L 2/04 3-J9158-2A CV_90CY.p65 Hitachi Home & Life Solutions, Inc. Hitachi Atago Building, Minato-ku, Tokyo, 105-8410 Japan Tel: 03 3502 2111 HITACHI EUROPE LTD. Benelux Branch Office...
Need help?
Do you have a question about the CV-90CY and is the answer not in the manual?
Questions and answers