Table of Contents
Advertisement
Be careful in handling the power cord.
•
Do not scratch, damage or process the power
cord. Do not bend it forcibly. Also do not put a
heavy object on it, do not heat it and do not pull
it. If you do, the power cord may be damaged
and it may cause a fire, electric shock, etc.
•Do not pull the cord.
•Do not put a heavy object on it.
•Do not damage the cord.
•Do not put it near a heating device.
•
Be careful that this unit is not placed on the
power cord. The power cord may be damaged
and it may cause a fire, electric shock, etc. If
the cord is covered with a carpet, etc. a heavy
object may be put on it without your realizing it.
•
If the cord is damaged (core wire is
exposed, disconnected, etc.), ask
your dealer to replace it. It may
cause a fire, electric shock, etc.
•
Check that no dirt adheres to the power plug and
fully insert without any play. If dirt adheres or
the connection is incomplete, it may cause a fire,
electric shock, etc.
•
The outer shield of power cord must
be connected to ground.
If you do not, it may cause a
electric shock.
Do not stare directly into the laser
aperture.
•
The laser pointer on the remote
control unit radiates the laser beam
from the laser aperture.
•
Do not stare into the laser aperture or radiate the
laser beam to other persons as the laser emitted
is a class II laser and it could damage you
vision, etc.
Especially pay attention if children are present.
Warning
•
The three labels below are caution labels for the
laser beam.
AVOIDE EXPOSURE–LASER
RADIATION IS EMITTED
FROM THIS APERTURE
LASER APERTURE
CLASS II LASER PRODUCT
RADIAZIONI LASER
CAUTION
NON GUARDARE NEL RAGGIO LUCE
APPARECCHIO LASER DI CLASSE 2
LASER RADIATION-
RAYONNEMENT LASER
DO NOT STARE INTO BEAM
NE PAS REGARDER DANS
LE FAISCEAU APPAREIL
WAVE LENGTH:670nm
A LASER DE CLASSE 2
MAX. OUTPUT:1mW
LASER-STRAHLUNG
NICHT IN DEN STRAHL
BLICKEN LASER KLASSE2
MANUFACTURED
August-97
MANUFACTURER:A
MADE IN JAPAN
Advertisement
Table of Contents
