When You Are Ready
To Set Up Your Tent
– Select a level campsite
clear of rocks, branches
and other hard or sharp
objects.
– Do not set up your tent
under trees.
– For best results in windy
conditions, position the
end of tent into the wind.
1
Layout & Positioning of Tent
– Layout and position tent with screen room
facing desired direction. (illus. 1)
– Stake down tent, starting with the corners.
Do not stretch too tight. Angle the stakes
slightly toward the tent. (illus. 2)
Keep the floor taut.
– Stake down the remainder
of the stake loops.
– Unzip the door.
2
Assemble & Place Roof Poles
– Assemble all shock-corded
roof poles. When assembled will
form a continuous arch with both
ends pointing down. (illus. 3)
– Select center curved roof poles,
and insert through the two center
roof sleeves and the front screen
room roof sleeve all with grey
webbing on sleeve ends. (illus. 4)
– Select rear roof pole, (orange
sticker), and insert through the roof
sleeve with orange webbing sleeve
end at rear of the tent. (illus. 4)
SCREENED WEATHERMASTER
Instructions apply to Part Number 2000000146
POLE ASSEMBLY PARTS
(3) Center Curved Roof Poles
Part No. 5010000474
(Orange Sticker) Part No. 5010000475
(2) Rear Brace Poles
(Orange Sticker) Part No. 5010000476
(6) Center Upright Poles
Part No. 5010000477
Rainfly Part No. 5010000478
(1) Vertical Hinge Door Pole (short with
plastic tips) Part No. 5010000479
(1) Hinge Door Pole (long with
plastic tips) Part No. 5010000480
illus. 1
Color coded
webbing
(1) Rear Pole
Roof sleeve
Forms an arch
Shock-corded poles
illus. 3 Curved roof pole assembly.
Roof pole sleeve
illus. 4
Curved roof pole system shown
inserted through pole sleeve.
®
ELITE 17'X9'
illus. 2
Stake loops
properly staked
Front of
screen
door
Color coded
webbing