Connect The Modem With Usb - Cisco LINKSYS ADSL2MUE Quick Installation Manual

1B

Connect the Modem with USB

A
Connect one end of the phone
to the ADSL (RJ-11 phone) port
on the back of the Modem.
NOTE: To use a USB connection, your
PC must use Windows 98SE, Me,
2000, or XP. The USB port is not
supported on other operating systems.
B
Connect the other end of the
phone to the wall jack with ADSL
service.
C
Connect the power adapter to
the Modem (C) and to the
electrical outlet.
D
Connect one end of the USB to
the USB port on the back of the
ADSL Modem and the other
end to the USB port on your PC.
E
Turn on the Modem.
NOTE: A small device called a microfilter
(not included) may be necessary between
each phone and wall jack to prevent
interference. Contact your ISP if you have
any questions.
IMPORTANT: Based upon the
requirements in your country, you should
make sure to only place the microfilters
between the phone and the wall jack and
not between the Modem and the wall jack.
Proceed to Step 2: Installing the USB
4
Driver.
A
B
C
D