Chapter 5: Connecting The Wireless A/G Usb Network Adapter; Connecting The Adapter; Figure 5-1: How The Adapter Connects To Your Pc; Figure 5-2: Adapter's Usb Port - Cisco LINKSYS WUSB54AG User Manual

Wireless A/G USB Network Adapter

Chapter 5: Connecting the Wireless A/G USB Network Adapter

NOTE: You must run the Setup Wizard before connecting the Adapter.

Connecting the Adapter

1. Connect one end of the included USB cable to the Adapter's USB port.
2. Connect the other end of the cable to one of the USB ports on your computer.
3. The Power LED should light up when the Adapter is plugged in.
4. Raise the antenna. Make sure the antenna points straight up into the air, at a 90º angle from the Adapter. This
will ensure optimum wireless operating range and performance.
NOTE: If you want to attach the Adapter to your wall, go to the next section,
"Using the Adapter's Wall Mount," before proceeding to "Chapter 6: Using the
Wireless Network Monitor."
Congratulations! The installation of the Wireless A/G Network Adapter is complete.
If you want to check the link information, search for available wireless networks, or make additional
configuration changes, go to "Chapter 6: Using the Wireless Network Monitor."
Chapter 5: Connecting the Wireless A/G USB Network Adapter
Connecting the Adapter

Figure 5-1: How the Adapter Connects to Your PC

Figure 5-2: Adapter's USB Port Figure 5-3: PC's USB Ports
12