Cisco LINKSYS WUSB100 Quick Installation page 6

Setup for Windows XP or 2000
WPA-Personal Needed for Connection
1.
Select your encryption method and
enter a Pre-shared Key.
Encryption
Select the encryption
method of your wireless network,
TKIP or AES.
Pre-shared Key Enter the Pre-
shared Key of your wireless
network. It must have 8-63
characters.
2.
Connect and go to step C.
Click
WEP Needed for Connection
1.
Select the level of encryption, and
then enter the Passphrase or WEP
Key.
WEP Select the level of encryption,
64-bit or 128-bit.
Passphrase Enter the Passphrase
of your wireless network. It is case-
sensitive and must have 16 or fewer
alphanumeric characters.
WEP Key
Enter the WEP Key of
your wireless network. For 64-bit
encryption, enter 10 hexadecimal
characters ("0" to "9" and "A" to "F").
For 128-bit encryption, enter 26
hexadecimal characters.
2.
Click Connect and go to step C.
6
WPA-Personal Needed for Connection
WEP Key Needed for Connection
C.
On the Congratulations screen, click
Finish.
D.
The Link Information screen of the
Wireless Network Monitor appears
the first time you run the Setup
Wizard. To exit the Monitor, click the
X in the upper right corner.
NOTE: After the Adapter is installed, the Wireless Network
Monitor screen opens, and its icon
system tray. You can double-click the icon to open the Monitor
if you want to find available wireless networks or change the
Adapter's configuration. For detailed information on the Monitor,
refer to the User Guide on the CD-ROM.
Congratulations! Setup is complete.
Setup for Windows XP or 2000
Congratulations
Connected to Network
appears in your computer's
7