Dimensions; Installation; Accessory Parts; Connection And Use Of Safety Valve - Haier FCD-JTSA50-III Service Manual

Service Manual
Model No:FCD-JTSA80-III

2-3. Dimensions

Chapter 3: Installation

3-1. Accessory parts

Part Name
Qty
Product Model
FCD-JTSA50-III
FCD-JTSA60-III
FCD-JTSA70-III
FCD-JTSA80-III

3-2. Installation

1. Installation must be made by installers of or designated by our company after-service department.
The water heatershall be wall-mounted.
2. Before installation, make sure water heater rear wires are fit firmly. Determine an installation location.
Make four holesφ12mm, 65 mm deep in the wall with an impact drill according to installating dimension.
Insert fixexpansion hooks and expansion bolts in corresponding wall holes. Lift the water heater. Insert
wall rack onto the hooks and bolts. Fit flat washers, rear wires and nuts in turn onto the bolts (see
Figure 2). Tighten the nuts and check them firm. Install accessories such as safety valve, drain hose as
shown in Figure 3. Use sealing compound to prevent water leakage.
3. To facilitate installation and removal, it is suggested a G 1/2" movable nut is fitted at appropriate
locations on inlet and outlet pipes respectively. Find water supply location. Connect inlet pipe, outlet
pipe and city water pipe respectively to the use point.
4. The hot water pipe shall not be too long to reduce the heat losses.
5. Please reserve some space in installation for the future maintenance.
Electic
Safety Expansio
water
valve n bolt
heater
1 1
1 1
1 1
1 1
-5-
Expansio User's
n hook manual
2 2 1
2 2 1
2 2 1
2 2 1
Drain
hose
1
1
1
1