Hitachi 42HDS69 Operating Manual page 12

Front/Rear/Side Panel Controls
POWER light indicator
To turn the TV ON, press the main power
switch located on the lower right side of the
TV. A red stand-by indicator lamp located on
the lower right corner of the front bezel will
illuminate. The Plasma TV is now ready for
remote ON/OFF operation.
Indicating Lamp Power Status
Lamp 1 Lamp 2
Off
Off
Lights
Off
Red
Blinking
Off
Blue
Lights
Off
Blue
Lights
Off
Orange
REMOTE CONTROL sensor
Point your remote at this area when selecting
channels, adjusting volume, etc.
Component SIDE INPUT JACKS (for INPUT: 5)
INPUT 5 provide Y-P
connecting equipment with this capability, such as
a DVD player or Set Top Box. You may use
composite video signal for this input.
NOTE: 1.
Your component outputs may be labeled
Y, B-Y, and R-Y. In this case, connect the
components B-Y output to the TV's P
input and the components R-Y output to
the TV's P
R
2. Your component outputs may be labeled
Y-C C . In this case, connect the component
B R
C output to the TV's P
B
component C
It may be necessary to adjust TINT to
3.
obtain optimum picture quality when using
the Y-P P
B R
INPUT 3, INPUT 4 and INPUT 5 (Y/VIDEO) can
4.
be used for composite video and component
video input.
NOTES: 1. Your HITACHI Plasma TV will appear to be turned OFF (lights orange) if there is no video input
when INPUT : 1, 2, 3, 4 and 5. Check the Power Light to make sure the TV is turned off or
in Stand-by mode (lights red) when not in use.
2. Remote Control can not turn ON/OFF the "MAIN POWER" of the TV.
12
Operating
OFF. When the main power switch is set to O .
When the main power switch on the TV
OFF.
(Stand-by) is ON.
OFF.
TV MAIN POWER is ON ; but no picture is shown.
(Turning ON )
O n
TV MAIN POWER is ON ; picture is shown.
TV MAIN POWER is ON with no signal input
Off
except antenna (no sync. signal).
(Power Saving)
P jacks for
B R
B
input.
input and the
B
output to the TV's P input.
R R
inputs (see page 37).
Lamp 1 Lamp 2