Starting And Operating; Power Button; New Vehicle Running-In; Ignition Switch Positions - Vauxhall KTA-2675/12-VX-en Owner's Manual

152 Driving and operating

Starting and operating

New vehicle running-in

Do not brake unnecessarily hard for
the first few journeys.
During the first drive, smoke may
occur because of wax and oil
evaporating off the exhaust system.
Park the vehicle in the open for a
while after the first drive and avoid
inhaling the fumes.
During the running-in period fuel and
engine oil consumption may be
higher and the cleaning process of
the diesel particle filter may take
place more often.
Diesel particle filter 3 159.

Ignition switch positions

Turn key:
0 = Ignition off: some functions
remain active until key is
removed or driver's door is
opened, if ignition was on
previously.
1 = Accessory power mode:
Steering wheel lock released,
some electrical functions are
operable, ignition is off.
2 = Ignition on power mode: Ignition
is on, diesel engine is
preheating. Control indicators
light up and the most electrical
functions are operable.
3 = Engine start. Release key after
starting procedure begins.
Steering wheel lock
Remove key from the ignition switch
and turn steering wheel until it
engages.

Power button

Electronic key must be inside the
vehicle.
Accessory power mode: press
Engine Start/Stop button once
without operating clutch or brake
pedal. The yellow LED in the button
illuminates. Steering wheel lock is
released and some electrical
functions are operable, ignition is off.