Hitachi 32HDX60 Operating Manual page 26

Avc (audio video control center) & plasma display monitor
Hide thumbs Also See for 32HDX60:
Table of Contents

Advertisement

CD, PVR, AMP buttons
When pressed, each of these buttons will blink to indicate the remote is in Audio mode or PVR mode (see page 39).
CHANNEL selector buttons
CHANNEL selector buttons are used to select channels, lock access code, etc.
Enter one, two, or three numbers to select channels. Enter "0" first for channels 1 to 9, or simply press the single digit channel you
wish to tune then wait a few seconds for the TV to tune. For channels 100 and above, press the "1" button, wait until two dashes
appear next to the channel display on your TV, then enter the remaining two numbers using the number buttons.
Channel selection may also be performed by pressing CH up ( ) or down ( ).
NOTE:
The Plasma TV may not receive some channels if you are not in the correct ANTENNA/CABLE mode (see page 50).
SLEEP button
Press this button to display the sleep timer in the lower center of the screen. Every subsequent press of this button will add 15 min-
utes to this timer, up to a maximum of three hours. Once set, use INFO when you want to view time remaining. If the SLEEP but-
ton is pressed while the timer is set, it will reset to the original condition.
INFO button
Press this button when you want to check the channel being received, the picture source, if the channel has stereo (ST) or second
audio program (SAP), the time, CHANNEL ID and if the SLEEP timer is set.
Day/Night
Day
Mode
Closed
Captioning
Off
CC
ANTENNA button
The ANT button will select between Antenna A and Antenna B each time the button is pressed.
TV/RGB button
Press this button to toggle between RGB (Analog) mode and TV mode.
3:32 PM
Ant A 22
Stereo
R
1080i Format
4:3 Expanded
0:00 AM
-:--
View
Zzzz
Off Timer
3:32 PM
Ant A 15
Stereo
G
HOW TO USE THE REMOTE
TO CONTROL YOUR PLASMA TV
Time
Main Picture Source
Audio Broadcast
Broadcast Rating
Signal Format
Wide
Mode
Sleep Timer
ANT
26
3:32 PM
When an S-VIDEO
S-IN:3
Input is connected to
VID 3
VIDEO: 3.
3:32 PM
When a COMPONENT
YPBPR:1
VIDEO: Y-P B P R Input
VID 1
is connected to
VIDEO: 1.
3:32 PM
Ant B 22
Stereo
R

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

42hdx6050hdx60

Table of Contents