Connecting Optional Equipment; External Outputs; Auxiliary Inputs - Crosley iJuke CR1701A Instruction Manual

Connecting Optional Equipment

External Outputs

The iJuke is equipped with external speaker outputs
which will allow you to hook up external speakers.
1
The speaker jacks for external speakers are 4
ohm jacks and are located on the back of the
unit. Beside the speaker jacks is the external /
internal speaker switch which is labeled (EXT.
/ INT.) When using external speakers, this switch
must be switched to the EXT. position. Doing
this turns off the internal speakers in the unit
and redirects to power to the external speakers.
2
If you decide not to use the external speakers,
be sure the switch is on INT. position or the
internal speakers will not work.

Auxiliary Inputs

You can connect external audio devices such as CD
Players or other MP3 players by using the Auxiliary
Input (Aux In) jack and the supplied Auxiliary cable.
To connect an external devise, follow the directions
below.
1
Connect one end of the supplied Auxiliary Cable
to the Aux In jack on the back of your unit.
2
Connect the other end of the cable to the Audio
Out Jack or Headphone Jack of your external
component.
Note: If your external component doesn't have a 3.5mm
output jack or headphone jack, you will need a
different cable to make the connection. Check
your local electronics retailer for different cable
options.
3
Begin play on the external component and adjust
the volume of the iJuke to your desired listening
level.
4
See the owner's manual for your external
component for information on its operations.
Auxiliary cable
9