Table of Contents
Advertisement
Mounting the subwoofer
1. Find a suitable location in the vehicle
in which to mount the amplifier.
A typical location is shown below:
Vehicle seat
SUB
REMOTE
BASS
LEVEL
SONIC
BOOST
LPF
2. Make sure there is sufficient air
circulation around the inteded
mounting location.
3. Mark the location for the mounting
hole screws by positioning the cabinet
where you wish to install it. Make a
small mark to identify the position and
remove the unit.
Thoroughly clean the area you plan to
attach the subwoofer, using a vacuum
cleaner.
POWER(GREEN)
PROTECT(RED)
PHASE
Connecting the subwoofer
Before doing any wiring, look through
this manual and identify the diagrams
to follow for power, input and speaker
connections for your particular
installation. Be sure you understand
all the connections before you proceed.
1. Connect the ground terminal to the
closest point on the chassis of the
vehicle. Keep this ground wire to less
than 39" (100cm) in length. Use 8
gauge (or heavier) wire.
2. Connect the remote terminal to the
remote output of the head unit using
16 gauge (or heavier) wire.
3. Connect an empty fuse holder within
18" (45cm) of the car battery, and run
8 gauge (or heavier) cable from this
fuse to the amplifier location.
4. Check that the fuse holder is empty.
Then connect the fuse holder to the
"BATT+" connection on the amplifier.
4
Hide quick links:
Advertisement
Table of Contents
