Advertisement
1. Open the rear cover using a flathead screwdriver (taking the IP8352 as an example).
2. Replace the seal plug on the rear cover with parts A & B from the waterproof connector.
3. Pass digital IO lines through F > E > C > A+B. Insert D into unused holes on C.
4. Connect DO lines to the GPIO terminal block (shown above). Secure the sealing nut (F)
by tightening to the rear cover.
5. Close the rear cover.
6. Pass IO lines through the mounting bracket.
2
1
(A)+(B)
3
(C)
(D)
(E)
(F)
(F)
4
5
(G)
6
6
Advertisement
