Rear Panel - YORKVILLE LP-C12 Owner's Manual

S t a g e L i g h t i n g
Lights
1 - 4
DESIGNED & MANUFACTURED BY YORKVILLE SOUND • TORONTO, CANADA
A-Z1228R / 1v0
r P
ear aneL
r F P
eSet tO aCtOry reSetS
This control that is accessed through a small hole in the rear panel returns all the settings and pre-
sets to the original factory settings. Normally in a rental pool of equipment this button will be used
to erase any setting done by the previous user. The unit must be powered for this control to be
effective. It will be necessary to use a tool to depress this control. A pen is usually a suitable tool.
THIS WILL ERASE ALL USER SETTINGS AND PRESETS.
F J
OOtSwitCh aCkS
Simple guitar dual foot-switches can be plugged into the jack on the rear panel to allow hands free
operation. The alternate action switches are interpreted by the LP-C12 as if they are momentary
switches. Depressing the switch initiates the same action as pushing a corresponding channel
on the LP-C12 front panel. The scene up and scene down switches increment or decrement the
active scene. All 13 scenes can be accessed. Incrementing above scene 13 returns to scene 1.
Decrementing below Scene 1 returns to scene 13.
a i
udiO n
This jack accepts line or speaker level signals to drive the audio effects and will work with most
audio signal levels.
It will begin to work at levels as low as 30 mV but requires 75 mV to operate properly. The maxi-
mum for proper operation is 100 volts RMS. Levels as high as 200 volts will not cause damage.
The inputs are balanced using the tip and ring connections. The sleeve (ground) is not fully con-
nected in order to eliminate ground loops and prevent short circuits in miss-wired speaker circuits.
L 1-4, 5-8 9-12
iGhtS and
These connections are intended to connect to Yorkville Sound LP series lighting devices. These
connections will not work with DMX devices. Signals are sent out these connections to the lights
and power is provided from the lights to the controller through these connections. When used with
the older LP304 and LP302 products, the gender will be reversed compared to the labeling on the
lights. This controller will work fine connected to the output connections of these older units even
though this is the reverse gender from the labeling.
Audio In
Lights
Lights
5 - 8
9 - 12
Black Out
Scene Up
OutPutS
LP -C12
Reset to
Factory Presets
Footswitches
Scene Dn Auto Adv
Scene 1 Effects
5