Specifications; Applications; Prior To Operation - Hitachi Koki EC 189 Instruction Manual And Safety Instructions

SPECIFICATIONS

Model
Motor
Power Source
Output Power
Current
Tank Capacity
Maximum Pressure
at 40 PSI (2.8 bar)
Free Air Delivery at 90 PSI (6.2 bar)
at 100 PSI (6.9 bar)
Lubrication

APPLICATIONS

Air source of the pneumatic nailer and stapler.
WARNING: Never use compressor for applications
other than compressor for pneumatic
nailer and stapler.

PRIOR TO OPERATION

1. Initial set-up
(1) Read safety warnings before setting-up this
compressor.
(2) Ensure the oil level in this compressor pump is
adequate. If the oil level is low, replenish oil
through the filling hole so that the amount of oil
will come to a point between the maximum notch
and the minimum notch on the pump oil dipstick
according to the following OIL TYPE CHART. (Fig.
2)
Pump oil dipstick
Fig. 2
2. Location
3. Electrical
Maximum
Minimum
— 9 —
EC189
Single-Phase, Induction Motor
Single-Phase, 115V AC 60 Hz
1.5 HP (1.1 KW)
13.2A
8 gal. (30.3 ltr)
125 PSI (8.6 bar)
7.2 CFM (204 ltr/min)
6.6 CFM (187 ltr/min)
6.5 CFM (184 ltr/min)
Oil
OIL TYPE CHART
Ambient 14~32 (°F)
temperature –10~0 (°C)
Non-detergent
SAE 10W
oil
(1) In order to avoid damaging this compressor, do
not incline this compressor transversely or
longitudinally more than 10°.
CAUTION: In order to avoid damaging the
compressor, do not allow the unit to be
tilted more than 10° when operating.
(2) Place this compressor at least 12 inches away
from obstacles that may prevent proper
ventilation. Do not place this compressor in an
area:
where there is evidence of oil or gas leaks.
where flammable gas vapors or materials may
be present.
where air temperatures fall below 14°F (–10°C)
or exceed 104°F (40°C).
where extremely dirty air or water could be
drawn into this compressor.
(1) Power source:
Ensure that the power source to be utilized
conforms to the power source requirements
specified on the product nameplate.
(2) Use of an extension cord is not recommended
because it could cause the motor to overheat. It's
preferable to use additional air hose instead of an
extension cord.
WARNING: Improper connection of the equipment-
grounding conductor can result in a risk
of shock or electrocution. Check with a
qualified electrician or service personnel if
you are in doubt as to whether the outlet
is properly grounded. Do not use any type
English
32~68 (°F) 68~104 (°F)
0~20 (°C) 20~40 (°C)
SAE 20W SAE 30