Installation Of Mounting Assembly - Waste King WLC-100 Owner's Manual

3. INSTALLATION OF MOUNTING ASSEMBLY

PLUMBER'S
PUTTY
MOUNTING
SCREWS
SCREW
CLAMP
RIDGE
HOPPER
END BELL
(ELECTRICAL
CONNECTIONS)
3B Mount Assembly
PROTECTOR
RING
SCREW
CLAMP
HUSH
CUSHION
3C
SINK
STOPPER
SINK FLANGE
PROJECTIONS
RIDGE
RUBBER SINK
FLANGE GASKET
PROTECTOR RING
MOUNT RING
HUSH CUSHION
DISHWASHER
DISCHARGE INLET
SCREWS
ELBOW
FLANGE
DISCHARGE
ELBOW
ELBOW
GASKET
SERIAL NUMBER:
RECORD ON FRONT OF
THIS OWNER'S GUIDE
SINK FLANGE
RUBBER
GASKET
MOUNTING
SCREWS
MOUNTING
RING
(Read completely before starting.)
3A
NOTE: Pay close attention to the order of mount
assembly parts, as they have been correctly
assembled by the factory.
A. Disassemble the mounting assembly, as it has
been shipped, by turning the sink flange until the
projections align with the notches in the mount
ring and allow you to pull the sink flange up and
out of the remaining mount assembly. Note the
sequence of these parts as they are stacked and
refer to 3A and 3B to identify each part. Unpack
the 3 mount screws and screw them half way
through the mount ring (notice "THIS SIDE UP" is
imprinted on top of the mount ring).
Next, stack the rubber gasket on top of the
protector ring and and sit them on top of the
pointed ends of the mount screws.
B. Keep these assembled parts together and set
aside. Before you connect the disposer to the
mount assembly under the sink, you may want
to practice engaging the GROOVE of the Hush
Cushion ® to the RIDGE at the bottom of the sink
flange (see 3A and read Section 6).
C. Be sure your sink is clean. Pack the underside
rim of the sink flange with plumber's putty (see
3C). Position the sink flange so it is centered and
readable as you look into your sink. Push the
sink flange firmly into the sink opening to make
a good seal. DO NOT move or rotate the sink
flange once seated or the seal may be broken.
D. Take the remaining portion of the mount assembly,
as it was set aside and make sure that the rubber
gasket is on top of the protector ring. From under
the sink, while holding the sink flange firmly with
one hand, line up the notches in the mount ring
with the projections of the sink flange. Slide the
mount assembly up onto the sink flange, past the
projections and give the mount assembly a 1/4
turn, so that it will hang by itself (see 3D).
E. Tighten the 3 mounting screws evenly with a
screwdriver (see 3E). DO NOT OVERTIGHTEN!
Trim off excess putty.
3D
3E