Page 4
Huawei Technologies Co., Ltd reserves the right to change or modify any information or specifications contained in this manual without prior notice or obligation.
4.3 Changing the IP Address..................... 4-2 4.4 Restoring Default Settings................... 4-2 5 Setting the Network-Access Parameters............5-1 5.1 Accessing the Network Through the Embedded PPP Dial-Up Software on the HG655a ............................5-1 5.2 Accessing the Network Through the PPP Dial-Up Software on Your Computer..5-2 6 Configuring the Voice Services .................
Page 10
Technologies Co., Ltd., tímto prohlašuje, že toto zařízení je ve shodě se základními požadavky a dalšími souvisejícími opatřeními směrnice 1999/5/EC. Dansk: Huawei Technologies Co., Ltd. erklærer hermed at denne enhed er i overensstemmelse me d de obligatoriske krav og andre relevante bestemmelser i direktiv 1999/5/EF.
Page 11
Magyar: Jelen nyilatkozaton keresztül a Huawei Technologies Co., Ltd. kijelenti, hogy a készülék megfelel az EC/5/1999 Irányelv összes lényeges követelményének és vonatkozó előírásának Gaeilge: Fograíonn Huawei Technologies Co., Ltd leis seo go bhfuil an fheiste seo i gcomhlíonadh leis na fíor-riachtanais agus na forálacha eile maid ir le Treoir 1999/5/AE.
VDSL/ADSL2+ interface, four FE interfaces, and two POTS interfaces. As a standard Home Gateway device, the HG655a provides VDSL2 uplink and ADSL2+ uplink dual backup to access the broadba nd WAN. For the LAN, it also provides bundant interfaces such as Ethernet interface to connect various household terminals, ch as PC, STB, and PHONE devices.
Blinking slowly The WAN connection is successfully established and data is being transmitted. The WAN connection is not established. The HG655a is powered off or the WAN connection is not yet established. The LAN connection is LAN1–LAN4 Green successfully established but no data is being transmitted.
User Guide Installation and Getting Started 3.1.2 Interfaces and Buttons The interfaces and buttons of the HG655a are located on the rear panel, as shown in Figure 3-2. Figure 3-2 Interfaces and buttons Figures of the front panel and the rear panel are only for your reference.
Power adapter 3.3 Getting Started To power on the HG655a, press the ON/OFF button on the rear panel of the HG655a. After you power on the HG655a, the DSL indicator blinks (for less than three minutes), which indicates that the HG655a is being activated. Later, the DSL indicator turns solid on.
If you forget the password that has been changed, you can restore the default settings of the HG655a by pressing and holding the RESET button for over six seconds. Then the password is restored to default value. After you restore the default settings, however, your customized data is lost.
4.4 Re storing Default Settings You can quickly restore the default settings of the HG655a by pressing the RESET button on the rear panel. To restore the default settings, press and hold the RESET button for over six seconds after the HG655a is po wered on, and then release the button.
5.1 Accessing the Network Through the Embedded PPP D ial-Up Software on the HG655a If you select this method for accessing the network, the HG655a starts to set up a dial-up connection auto matically after the startup. You can access the network after you power on your computer.
If you select this method for accessing the network, you need to install and configure the dial-up software on your computer. In addition, you need to perform dial-up operations on your computer upon each startup . To configure the HG655a and your computer for the network access, do as follows: Step 1 Set the working mode of the HG655a to Bridge.
6.1 In troduction The HG655a supports voice services based on the Session Initiation Protocol (SIP). The SIP is an application layer protocol used to create, modify, or end multimedia sessions. Based on text coding, the SIP references the Hyper Text Transport Protocol...