Do you have a question about the BWR300BL and is the answer not in the manual?
Questions and answers
Eric Gerhardt
March 23, 2025
My koldfront wine cooler model bwr300bl Will not power on. We had a power outage. And I just noticed that the wine cooler will not power back on when I pushed the power button. The number ford displays
1 comments:
Mr. Anderson
March 23, 2025
Your Koldfront wine cooler model BWR300BL may not power on after a power outage due to the following reasons:
1. Power Failure – Ensure the power outlet has electricity. 2. Unplugged Unit – Make sure the cooler is properly plugged into a working power outlet. 3. Blown Fuse or Tripped Circuit Breaker – Check your fuse box and replace a blown fuse or reset the circuit breaker. 4. Wait Time After Power Off – If the unit was recently powered off, wait at least 5 minutes before turning it back on.
Check these factors to restore power to your wine cooler.
Important Safety Information Improper handling can cause serious damage to the EdgeStar wine refrigerator and/or injury to the user. This wine refrigerator is designed for domestic indoor use only. Do not use the unit for industrial or commercial use. Any other use may invalidate the warranty.
The instruction manual should be read before use. This owner’s manual is provided for reference use only. Specifications may change without prior notice. Refer to the product label on the back of your wine refrigerator for the latest technical information. Koldfront Wine Refrigerator...
Introduction Thank you for purchasing this Koldfront wine refrigerator. We are glad you chose us. We believe that your purchase of this product opens a relationship between you and EdgeStar. We will provide the customer support needed to nurture that relationship.
Small Shelf Bottom Door Frame Front vent Leveling foot Back View Product Label Tip: Gather the model and serial number from the product label and write them down before installing the wine refrigerator. Power Cord Power Plug Cabinet Koldfront Wine Refrigerator...
Installing the Wine refrigerator The wine refrigerator should be installed in accordance with local electrical code requirements. The wine refrigerator should also be placed in a location that is strong enough to support its total weight, keeping in mind that it will weigh substantially more when fully loaded than when empty.
See the “Leveling the Wine refrigerator” section. • A standard electrical supply (115 VAC only, 60 Hz), properly grounded in accordance with National Electrical Code and local codes and ordinances is required. Koldfront Wine Refrigerator...
Electrical Requirements • Plug into a grounded 3-prong outlet. • Never remove the grounding prong from the plug. • Never use an adapter to bypass the grounding prong. • DO NOT use an extension cord. • Failure to follow these instructions can result in fire, electrical shock, or death.
3. Pull the shelf forward until the notch aligns with the plastic post on each side of the shelf track. 4. Lift the shelf until both notches pass through the posts. 5. Continue to pull the shelf forward until it is completely removed from the inner compartment. Koldfront Wine Refrigerator...
Reversing the Door Swing Follow the instructions below to reverse the door swing. IMPORTANT: Before you begin, unplug the refrigerator. To reverse the door from right swing to left swing: 1. Open the door and using a Phillips screwdriver, remove the bottom screws from the lower hinge.
The Celsius or Fahrenheit light will be lit depending on what scale temperature is being displayed. To switch between C and F, press and hold the buttons at the same time for approximately 5 seconds until the temperature scale changes. Koldfront Wine Refrigerator...
Normal Sounds Your new wine refrigerator may make sounds that are not familiar to you. Most of the new sounds are normal. Hard surfaces like the floor, walls can make the sounds seem louder than they actually are. The following describes the kinds of sounds that might be new to you and what may be making them.
Make sure the door is completely closed. closed. on and off frequently. The door gasket is not Make sure the door gasket is properly sealing. sealing properly. The cooler does not have the Read and follow the “Installation Clearance suggested ventilation. Requirements” section. Koldfront Wine Refrigerator...
Troubleshooting continued Issue Possible cause Solution Ensure the cooler is plugged in and the power outlet has There is a power failure. power. Plug the unit in to a power outlet that has sufficient The cooler is not plugged in. The wine cooler does not amperage.
Note: Technical data and performance information is provided for reference only. Specifications are subject to change. Check the rating label on the wine refrigerator for the most accurate information. *Note on wine storage capacity: The wine refrigerator will store 30 standard 750 ml. wine bottles. Koldfront Wine Refrigerator...
Limited Warranty: Full One-Year Parts and Labor This product is warranted by EdgeStar and is subject to any conditions set forth as follows: WHAT IS COVERED: WHAT IS NOT COVERED - The following limitations apply to the coverage of this warranty. This warranty does not cover: For a period of ONE (1) YEAR from the date of original retail purchase, EdgeStar will repair or -Labor charges for installation, setup or training to use the...
Page 17
EdgeStar Products 500 N. Capital of TX Hwy, Bldg 5 Austin, TX 78746 Toll Free: 1-866-319-5473 Web: http://www.edgestar.com E-mail: service@edgestar.com Register your product, download owner’s manuals, access additional troubleshooting resources, and obtain more information on other great EdgeStar products on the web at: http://www.edgestar.com Product contents and specifications may change without notice.
Need help?
Do you have a question about the BWR300BL and is the answer not in the manual?
Questions and answers
My koldfront wine cooler model bwr300bl Will not power on. We had a power outage. And I just noticed that the wine cooler will not power back on when I pushed the power button. The number ford displays
Your Koldfront wine cooler model BWR300BL may not power on after a power outage due to the following reasons:
1. Power Failure – Ensure the power outlet has electricity.
2. Unplugged Unit – Make sure the cooler is properly plugged into a working power outlet.
3. Blown Fuse or Tripped Circuit Breaker – Check your fuse box and replace a blown fuse or reset the circuit breaker.
4. Wait Time After Power Off – If the unit was recently powered off, wait at least 5 minutes before turning it back on.
Check these factors to restore power to your wine cooler.
This answer is automatically generated