Installing And Disassembling The Door Handle; Setting Up The Refrigerator - Samsung Refrigerator User Manual

instaLLing anD DisassEMBLing tHE Door HanDLE

Installing the Door Handle
1. Match the Handle Locking Tabs installed on the left hand side of the door and
the handle inserts.
2. Fix the handle by pulling it down or tapping it lightly with a tool like a rubber hammer.
3. Check whether the locking tabs inside the handle are assembled by pulling it up and down.
Disassembling the Door Handle
1. Separate the locking tabs by tapping the lower part of the handle with a tool
like a rubber hammer.
2. Pull the handle up to detach the locking tabs from the handle inserts and
separate each other.

sEtting uP tHE rEfrigErator

Now that you have your new refrigerator installed and in place, you are ready to set up and
enjoy the full features and functions of the appliance.
By completing the following steps, your refrigerator should be fully operational. If not, first check
the power supply and electricity source or try the troubleshooting section at the back of this
user guide. If you have any further questions, contact your Samsung Electronics service center.
1. Place the refrigerator in an appropriate location with reasonable clearance between
the wall and the refrigerator. Refer to installation instructions in this manual.
2. Once the refrigerator is plugged in, make sure the interior light comes on when
you open the doors.
3. Set the temperature control to the coldest temperature and wait for an hour.
The freezer should get slightly chilled and the motor should run smoothly.
4. After powering the refrigerator, it will take a few hours to reach the appropriate temperature.
Once the refrigerator temperature is sufficiently cool, you can store food and
drink in the refrigerator.
There is a possibility of the
handle detachment when
CAUTION
excessive force is applied to
the handle during relocation
of the refrigerator, so do not
grab the handle.
_9
setting up