Connections
Speaker Components
(L) (R)
FRONT
STAND
(L)
(R)
SURROUND
SUBWOOFER
Installing the Speakers on the Tallboy Stand
1.
Turn the Stand Base upside-down and connect it
to the Stand.
2.
Insert small screws (4x20, For connecting Stand &
Stand Base) clockwise into the four holes marked
using a screwdriver as shown in the illustration.
!
CAUTION
When you use a torque screwdriver, be careful not
to put excessive force. Otherwise, it runs idle or
can be damaged. (torque screwdriver- below 15
kg.f.cm)
3.
Connect the upper Speaker to the assembled
Stand.
4.
Insert another large screw (5x15, For connecting
Speaker & Stand) clockwise into the hole on the
rear of the speaker using a screwdriver.
5.
This is the appearance after the speaker is
installed. Follow this steps to install other speaker.
20
English
HT-D5330_XAC_0215.indd 20
HT-D5330_XAC_0215.indd 20
Assembled Speakers
SCREW (5X15): 2EA
SCREW (4X20): 8EA
SPEAKER CABLE
CENTER
STAND BASE
1
3
5
CENTER SPEAKER
FRONT SPEAKER
SURROUND
SPEAKER
2
Stand
Base
Stand
4
Speaker
Stand
SUBWOOFER
2011-02-15 ¿ÀÈÄ 7:38:31
2011-02-15 ¿ÀÈÄ 7:38:31