Table of Contents
Advertisement
HOW TO USE BATH MAT AND MOTOR HOUSING
1) Remove bath mat, motor housing, soft surface mat, and air hose from packaging.
Do not fill tub first.
2) Insert one end of the air hose into the female receptacle on one end of the mat. Press
in firmly.
3) Place mat into tub with hose end towards the front of tub. Press mat firmly down to engage
suction cups on bottom of mat. Suction cups may lose grip on textured surfaces or tubs with
some dirt buildup. Clean area and moisten suction cups to increase suction cup grip.
4) Place motor housing on the floor conveniently between the bathtub and electrical outlet.
Never place the motor housing where it can fall into the tub. Have the motor housing face the
user in the tub, as the infrared Remote Control needs to be aimed by the user towards the
motor housing.
5) Plug motor housing into 120 V AC outlet. See ALCI operating instructions to familiarize
yourself with ALCI use and function.
6) Insert the other end of the air hose into the motor housing.
7) Test the Unit by pushing rocker switch on the front of appliance to "HIGH". You should hear
the motor turn on.
8) Test operation of the Remote Control by pushing the rocker switch to the "REMOTE" posi-
tion. Now press the remote's power "ON" button; motor will run on the "HIGH" setting. Try
other settings to become familiar with the unit's operation. (See "How To Use Remote Control")
9) Now fill the bathtub with the amount and temperature of bath water desired. Turn on unit to
desired setting.
10) Exercise extra caution getting into and out of the bathtub.
11) The bath mat massager will not keep hot bath water heated. Even on the HIGH setting,
the user should expect hot bath water to cool off.
12) Use of salts and oils is acceptable with your Bath Mat Massager. Please clean the bath
mat with fresh tap water before storing. Also note that your additions of salt or oil may make
tub and bath mat surfaces slippery.
13) After use, be sure you are dry before unplugging power unit.
14) To store, drain all water from the bath mat sections by rotating gently over the bathtub.
Disconnect the air hose from the power unit and drain air hose into tub as well. After all free
water has dripped into the tub, gently wipe any wet surfaces with a clean dry towel before
storing.
15) Dry the Remote Control Power Module after use. Avoid submerging or having control float
on water for long periods of time.
Advertisement
Table of Contents
