Dispensing Hot Water - Black & Decker 900143 User Manual

Dispensing Hot Water

This unit dispenses water at temperatures that can cause severe burns. Avoid
direct contact with hot water. Keep children and pets away from unit while
dispensing. Never allow children to dispense hot water without proper and
direct supervision. Unplug unit to prevent unsupervised use by children.
Note: If you do not want to dispense hot water, flip the switch on the back of the
unit to OFF.
Note: After setup, hot water will be available in 15-20 minutes.
1. Position bottle, glass, pitcher or cooking pot securely below hot water tap.
The red arrowhead below the hot water control indicates the location of the hot
-
water tap.
The circular shapes in the drip plate help align the flow of water. This unit
-
dispenses water at a fast rate. To avoid splashes, hold cup as close to the tap
as possible.
2. Push red hot water release inward and depress hot water control downward to start
flow.
3. Release hot water control once desired fill level is achieved.
Replacing an Empty Bottle
Replace bottle as soon as you notice it is empty. Unplug unit if bottle and tanks
are empty.
1.
Lift bottle straight up to disengage from the bottle probe.
2.
Clean fresh water bottle with a soft cloth and warm soapy water, then rinse.
3.
Remove tamper seal from top of bottle cap. Do NOT remove plastic cap.
4.
Lift bottle and insert onto the probe. Apply slight pressure until the plug inside the
cap pushes in and the bottle is seated.
5.
Dispense some water from the COLD tap until air bubbles appear in the bottle.
Model # 900143: Page 8