Hand-Held Remote Control Troubleshooting - Niles ZR-4 Installation Manual

TROUBLESHOOTING continued
SOLUTION:
• Call Niles Tech Support
PROBLEM:
6. Poor or no radio reception
SOLUTION:
• Check the receiver's back panel to see if the FM dipole and AM
loop antennas are connected. It may be necessary to reposition
them to optimize reception.
PROBLEM:
7. Keypad does not function
SOLUTION:
• Make sure that the CAT-5 cable is terminated using T568A
wiring convention.
(See Figure 2)
• Check that the RJ-45 connector is firmly seated in the back of
the keypad
PROBLEM:
8. No source control

HAND-HELD REMOTE CONTROL TROUBLESHOOTING

PROBLEM:
1. LED does not blink when you press a key.
SOLUTION:
• Try pressing different keys. Replace the batteries with 2 new
AA batteries
PROBLEM:
2. LED blinks when you press a key, but device does not respond.
SOLUTION:
• Make sure the remote is aimed at your device and is not more
than 40 feet away
PROBLEM:
3. LED blinks one long blink while in SETUP mode.
SOLUTION:
• An entry error has occurred (for example, wrong key). Try
entering the sequence again
PROBLEM:
4. Remote does not control devices or commands are not working
properly.
26
SOLUTION:
• The infrared MicroFlasher
®
back of the receiver
• The infrared MicroFlasher
®
controlled component
• The batteries in the hand-held remote control are dead
• The IR Sensor is turned off (see page 22)
PROBLEM:
9. A Zone does not turn on when in the Party Mode
SOLUTION:
• Check the system configuration settings for PARTY OR WHOLE
HOUSE MODE
(page 19)
PROBLEM:
10. A Zone does not turn on when in the Paging Mode
SOLUTION:
• Check the system configuration settings for PAGING
(page 19)
SOLUTION:
• Try all listed codes for the device. Make sure the device
operates with an infrared remote control
PROBLEM:
5. CH+, CH-, and LAST do not work for your RCA TV.
SOLUTION:
• Due to RCA design from 1983 to 1987, only the original remote
control will operate these functions
PROBLEM:
6. Channels do not change properly when directly entering digits to
change channels.
SOLUTION:
• If the original remote control required you to press Enter to
change channels, press Enter on this remote after entering
the channel number
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373
is not connected properly to the
is not affixed properly to the