Temperature And Humidity; Ice Warning; Placing Of Unit - Oregon Scientific EW102 User Manual

• Position the sensor close to the main unit during cold
winter months as below-freezing temperatures may
affect battery performance and signal transmission.
TIP The transmission range may vary depending on many
factors. You may need to experiment with various locations
to get the best results.
NOTE Use alkaline batteries for longer usage and consumer
grade lithium batteries in temperatures below freezing.

TEMPERATURE AND HUMIDITy

To select temperature unit:
Slide °C / °F switch.
To toggle between each sensor's readings:
Press CHANNEL repeatedly
OR
Press and hold CHANNEL for 2 seconds to initiate auto
toggle of channel readings.
To end, press CHANNEL.
To toggle between current, minimum and maximum
records for the past 24 hours:
Press MIN. MAX. repeatedly.
To clear the records:
Press and hold MIN. MAX.

ICE WARNING

If temperature recorded falls between -2°C to 3°C (29°F to
37°F), LED indicator will flash and will stop flashing once the
temperature is out of this range.

PLACING OF UNIT

Mounting on metallic surface:
Place onto surface.
Mounting on wall:
Use wall mount hole.
Placing on a flat surface:
1. Remove battery compartment cover.
2. Remove pole from casing.
3. Replace battery compartment cover.
4. Insert pole through hole and place in desired position.
5