Specifications; Troubleshooting Guide - Desa Dual Brite PF-4125-AZ Manual

SPECIFICATIONS

Range . . . . . . . . . . . Up to 30 ft. (9.1 m)
Sensing Angle . . . . . Up to 150°, 240°
Electrical Load . . . . . See rating on fixture
Sensor Capacity . . . Up to 360 Watts (3.0
Power Requirements 120 VAC, 60 Hz
Operating Modes . . . TEST, AUTO, and
Time Delay . . . . . . . 1, 5, 10 minutes
D B Timer . . . 3, 6 hours, dusk-to
®
ual rite
DESA Specialty Products reserves the
right to discontinue products and to change
specifications at any time without incurring
any obligation to incorporate new features
in products previously sold.
SYMPTOM POSSIBLE CAUSE
Light will not
1. Light switch is turned off.
come on.
2. Bulb is loose or burned out.
3. Fuse is blown or circuit breaker
4. Daylight turn-off is in effect
5. Incorrect circuit wiring, if this
6. Re-aim the sensor to cover
Light comes
1. Light Control may be installed
on in daylight.
2. Light Control is in Test. (Set
Light comes
1. Light Control may be sensing
on for no ap-
parent reason.
2. Sensitivity is set too high.
598-1166-03
[varies with surrounding
temperature].
adjustable
for maximum wattage
A.) Maximum
MANUAL MODE
dawn

TROUBLESHOOTING GUIDE

is turned off.
(recheck after dark).
is a new installation.
desired area.
in a relatively dark location.
control switch to an ON-TIME
position.)
small animals or automobile
traffic (re-aim sensor).
(Reduce sensitivity.)
SYMPTOM POSSIBLE CAUSE
Light stays on
1. The sensor is pointed at nearby
continuously.
2. The sensor is pointed toward
Light flashes
1. Heat being reflected from other
on and off.
7
objects that cause heat to trigger
the sensor. (Aim the sensor
away from nearby objects.)
a heat source like an air vent,
dryer vent, or brightly-painted
heat-reflective surface. (Re-
aim sensor.)
objects may be affecting the
sensor. (Re-aim sensor.)