Lights of America Motion Sensing Diecast Metal Lantern 9600LED series Owner's Manual page 2

Wiring
Warning: turn power off at circuit breaker
or fuse.
Note: All wiring should be run in accordance with the
National Electrical Code through conduit or another
acceptable means. Contact a qualified electrician
if there is any question as to the suitability of
the system.
CautiOn: DO nOt connect the reD wire
unless you want to control other lights from
the motion sensor (see Optional Wiring).
Black
Green or
Bare
White
One Motion Light
White
Black
Green or
Bare
Two Motion Lights
Light
Fixture
Light Light
Fixture Fixture
Connect the fixture wires to the wires in the junction
box. Twist the wires together and secure with wire
connectors.
recommended grounding method
Use a green ground "pigtail" (not provided) and
twist one end together with the bare fixture wire
and the box ground wire. Secure with a wire con-
nector. Secure the other end of the "pigtail" with
the GND screw on the X-bar.
Black to black
If you have metal junction box, you may not need the
green "pigtail". If you are unsure about the grounding
method, consult your local building code.
2
White to white
598-1338-03