General Information; Operating The Tv With A Universal Or Sky (Bskyb) Remote Control - Technika LCD 32-248 User Manual

Lcd tv lcd 32-248

Hide thumbs

Table Of Contents

Table of Contents

OPERATING THE TV WITH A UNIVERSAL

OR SKY (BSKYB) REMOTE CONTROL

Using a Universal Remote Control.

You may wish to use a Universal Remote control to operate your Television. In order to do so, you

will need to enter the 'code' below into your universal remote control, to do this, please follow the

instructions included with the Universal remote control. Please note that if your remote control does not

accept the code, this is because the software/ﬁ rmware installed on the remote control is too old. Please

contact the manufacturer of the Universal Remote control for assistance.

Universal Remote Code - 2106 (TV functions)

Using a Sky / Sky+ / Sky HD Remote Control

If you wish to use your Sky remote control to operate your Television, you need to programme a 4 digit

code into your Sky, Sky+ or Sky HD remote control.

Please note that the code below will only be accepted if the Sky remote control is a Revision 9 (launched

Autumn 2010) or later.

To ﬁ nd out which version of Sky remote you have, remove the battery cover, you should see a sticker

showing the 'Rev' number.

If your Sky remote is Rev 8 or earlier, you will need to purchase a new Sky Remote control in order to

operate the TV's functions. At the point of manufacture of this TV, the latest Revision 9 remote controls

are only available to purchase directly from Sky, alternatively, you can purchase our versions from the

helpline / website.

Sky

If your Sky remote control is a Revision 9 or later, please follow the instructions below.

1) Switch on the TV set

2) Press the 'TV' button on the Sky Remote

3) Hold down the 'select' and 'red' buttons for 2-3 seconds until the LED blinks twice

4) Press the 'TV' button on the Sky Remote again

5) Enter the 4 digit code (see below)

6) The LED should blink twice, if not recheck the 4 digit code used and go back to step 1

7) Press the 'standby' button on the Sky Remote (The TV should go to standby)

8) Press 'select' to store this setting

Sky / Sky+ / Sky HD Remote code - 2134 (Revision 9 or later only)

User Guide - Technika - LCD 32-248, 40-248.indd Sec1:26

The very latest versions of remote controls to operate your Sky

/ Sky+ / Sky HD in addition to operating the functions of the

Television can be purchased from the helpline or website.

www.skymediauk.co.uk

Our versions (from One for All) are slightly smaller than the

regular Sky remotes and operate your Sky box the same way

your current Sky remote does, in addition, our versions operate

the functions of your television as they include the very latest

software/ﬁ rmware.

Please note that as we have to install the necessary software /

ﬁ rmware onto the remote control prior to shipping, you must

provide us with your TV model number in order that we can

do this.

Sky+/Sky HD