Duty Cycle; Assembly - Craftsman 919.724320 Owner's Manual

Air compressors should be operated
on not more than a 50% duty cycle.
This means an air compressor that
pumps air more than 50% of one
hour is considered misuse, because
Contents of Carton
1 - Air Compressor
2 - Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
2 - Rubber Bumpers
2 - Screws, 1/4-20 x .75"
Tools Required for Assembly
1 - 9/16" socket or open end wrench
1 - 1/2" socket or open end wrench
Unpacking
1. Remove all packaging leaving
the air compressor on the pallet.
2. Remove and discard the (4)
screws holding the air compres-
sor to the pallet.
Screws
support one side of the air com-
pressor when removing the pallet
because the air compressor will
have a tendency to tip.
3. Carefully remove the air com-
pressor from the pallet.
D24544

DUTY CYCLE

ASSEMBLY

It may be neces-
sary to brace or
the air compressor is undersized for
the required air demand. Maximum
compressor pumping time per hour is
30 minutes.
Assemble Wheels
one side of the outfit when
installing the wheels because the
compressor will have a tendency to
tip.
1. Attach wheels with shoulder
bolts and nuts as shown.
Nut
2. Tighten securely. NOTE: The out-
fit will sit level if the wheels are
properly installed.
vide adequate clearance, stability
or support for pulling the unit up
and down stairs or steps. The unit
must be lifted, or pushed up a
ramp.
Assemble Rubber Feet
1. Attach rubber feet with the
screws provided as shown in
previous figure.
2. Tighten securely.
10- ENG
It will be necessary
to brace or support
Rubber
Feet
Screw
Wheel
Shoulder
Bolt
The wheels and
handle do not pro-