AOC 2236Vwa User Manual

Hide thumbs Also See for 2236Vwa:

User manual (61 pages)

Service manual (48 pages)

Specifications (1 page)

Quick Links

Need help?

Do you have a question about the 2236Vwa and is the answer not in the manual?

Questions and answers

Summary of Contents for AOC 2236Vwa

Page 1: Table Of Contents
AOC MONITOR USER`S GUIDE 2236Vwa SAFETY INTRODUCTION…………………………………………………………….2 SETUP…………………………………………………………………………………….5 ADJUSTING…………….…………………………………………………...……………9 DRIVER INSTALLATION GUIDE…………………….….………………………….16 PRODUCT INFORMATION…………………………………………………………..24 TROUBLESHOOT……...………………………………………………………….…...26 P a g e ١...
Page 2: Safety Introduction
SAFETY INTRODUCTION The following subsections describe notational conventions used in this document. Notes, Cautions, and Warnings Throughout this guide, blocks of text may be accompanied by an icon and printed in bold type or in italic type. These blocks are notes, cautions, and warnings, and they are used as follows: NOTE: A NOTE indicates important information that helps you make better use of your computer system.
Page 3 See below the recommended ventilation areas around the monitor when the monitor is installed on the wall or on the stand: Clean the cabinet regularly with the cloth provided. You can use soft-detergent to wipe out the stain, instead of strong-detergent which will cauterize the product cabinet.
Page 4 If the product is emitting a strange smell, sound or smoke, disconnect the power plug IMMEDIATELY and contact a Service Center. Make sure that the ventilating openings are not blocked by a table or curtain. Do not engage the LCD monitor in severe vibration or high impact conditions during operation.
Page 5: Setup
SETUP Not all signal cables (Analog, DVI, USB, Audio, and HDMI cables) will be provided for all countries and regions. Please check with the local dealer or AOC branch office for confirmation. P a g e ۵...
Page 6 Please setup or remove the base following the steps as below. Remove:  For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor's angle to your own preference.  Hold the stand so you will not topple the monitor when you change the monitor's angle. ...
Page 7 Cable Connections On Back of Monitor and Computer 1. Power 2. Analog (DB-15 VGA cable) 3.Audio 4.DVI To protect equipment, always turn off the PC and LCD monitor before connecting. Connect the power cable to the AC port on the back of the monitor. Connect one end of the 15-pin D-Sub cable to the back of the monitor and connect the other end to the computer's D-Sub port.
Page 8 Noted : VESA mounting screw holes are not available for all models, please check with the dealer or official department of AOC. Distance between the wall-mount holes : 100 x 100 mm Screw specification for wall-mount : M4 x 10 P a g e ٨...
Page 9: Adjusting
Adjusting The recommended resolution for this monitor is 1920 by 1080. To setup the monitor to this resolution, follow the steps below. For Windows Vista: 1 Click START. 2 Click CONTROL PANEL. 3 Click Appearance and Personalization. 4 Click Personalization P a g e ٩...
Page 10 5 Click Display Settings. 6 Set the resolution SLIDE-BAR to 1920 by 1080. For Windows XP: 1 Click START. 2 Click SETTINGS. 3 Click CONTROL PANEL. P a g e ١٠...
Page 11 4 Click Appearance and Themes. 5 Double click DISPLAY. 6 Click SETTINGS. 7 Set the resolution SLIDE-BAR to 1920 by 1080. For Windows ME/2000: 1 Click START. 2 Click SETTINGS. 3 Click CONTROL PANEL. 4 Double click DISPLAY. 5 Click SETTINGS. 6 Set the resolution SLIDE-BAR to 1920 by 1080.
Page 12: Osd Setting
Power Press to turn on or turn off the monitor. 4:3 or wide / Up Press key to change the screen aspect ratio between standard 4：3format or Wide format. When the input resolution wide format, the aspect ratio hotkey is disabled. When the main menu or sub-menu is active, the key functions as to select up or increase value.
Page 13 Eco mode ---DCR, Standard, Text, Internet, Game, Movie, Sports Standard P a g e ١٣...
Page 14 TEXT INTERNET Game P a g e ١۴...
Page 15 Movie Sports Notes : When Eco mode is not set as “Standard”, Contrast and Brightness can not be adjusted; When DCR is set as “On”, Contrast, Brightness, Eco mode and Gamma can not be adjusted. P a g e ١۵...
Page 16 LED INDICATOR Status LED Color Full Power Mode Blue Active-off Mode Orange P a g e ١۶...
Page 17: Driver Installation Guide
DRIVER INSTALLATION GUIDE Windows 2000 1. Start Windows® 2000 2. Click on the 'Start' button, point to 'Settings', and then click on 'Control Panel'. 3. Double click on the 'Display' Icon. 4. Select the 'Settings' tab then click on 'Advanced...'. 5.
Page 18 3. Select and click on the category ‘Appearance and Themes’ 4. Click on the 'Display' Item. 5. Select the 'Settings' tab then click on the 'Advanced' button. P a g e ١٨...
Page 19 6. Select 'Monitor' tab - If the 'Properties' button is inactive, it means your monitor is properly configured. Please stop installation. - If the 'Properties' button is active, click on 'Properties' button. Please follow the steps below. 7. Click on the 'Driver' tab and then click on 'Update Driver...' button. 8.
Page 20 9. Select the 'Don't Search. I will choose the driver to install' radio button. Then click on the 'Next' button. 10. Click on the 'Have disk...' button, then click on the 'Browse...' button and then select the appropriate drive F: (CD-ROM Drive). 11.
Page 21: Windows Vista
Windows Vista 1. Click "Start " and "Control Panel". Then, double-click on "Appearance and Personalization". 2. Click "Personalization" and then "Display Settings". 3. Click "Advanced Settings...". P a g e ٢١...
Page 22 4. Click "Properties" in the "Monitor" tab. If the "Properties" button is deactivated, it means the configuration for your monitor is completed. The monitor can be used as is. If the message "Windows needs..." is displayed, as shown in the figure below, click "Continue". 5.
Page 23 9. Click "Close" → "Close" → "OK" → "OK" on the following screens displayed in sequence. I_MENU Welcome to “i-Menu” software by AOC. i-Menu makes it easy to adjust your monitor display setting by using on screen menus instead of the OSD button on the monitor. Please click to setup the software.
Page 24: Product Information
PRODUCT INFORMATION model name 2236Vwa Driving system TFT Color LCD Viewable Image Size 547mm diagonal Pixel pitch 0.248mm(H) x 0.248mm(V) LCD Panel Video R, G, B Analog lnterface & Digital Interface Separate Sync. H/V TTL Display Color 16.7M Colors Dot Clock 148.5 MHz...
Page 25 HORIZONTAL VERTICAL STAND RESOLUTION FREQUENCY(kHZ) FREQUENCY(Hz) 640×480 @60Hz 31.469 59.940 640×480 @67Hz 35.000 66.667 640×480 @72Hz 37.861 72.809 640×480 @75Hz 37.500 75.000 Dos-mode 720×400 @70Hz 31.469 70.087 SVGA 800×600 @56Hz 35.156 56.250 SVGA 800×600 @60Hz 37.879 60.317 SVGA 800×600 @72Hz 48.077 72.188 SVGA...
Page 26: Troubleshoot
Adjust the maximum resolution and frequency that the monitor can handle properly. Make sure the AOC Monitor Drivers are installed (AOC Monitor Drivers are available at : here)  Adjust the Contrast and Brightness Controls.
Page 27 ON or OFF after hitting the CAPS LOCK key. Missing one of  Inspect the monitor's video cable and make sure that no pin is damaged. the primary  Make sure the monitor's video cable is properly connected to the computer. colors (RED, GREEN, or BLUE)

AOC 2236Vwa User Manual

Quick Links

Need help?

Questions and answers

Related Manuals for AOC 2236Vwa

Summary of Contents for AOC 2236Vwa