Disarming Without A Transmitter; Valet Mode - Autopage C3-RS-915 LCD Operation Manual

Professional 2-way lcd remote car starter & alarm system with built in temperature & voltage sensor and two-way serial port data link
Table of Contents

Advertisement

SVMASTER
-
TWO STEPS DOOR UNLOCK (Optional): This feature will independently unlock the driver's door only when
disarming the security system. Pushing the
doors.
AUTOMATIC RE-ARM: If this feature is selected, the security system will automatically re-arm itself in 60
seconds after disarming with remote transmitter. Automatic rearm will cancel if any door is opened before the
60 seconds timer has elapsed.
H. DISARMING WITHOUT A TRANSMITTER
OVERRIDES THE ALARM WITHOUT PASSWORD PIN CODE:
The Override function may be used if the remote transmitter is lost or inoperative.
1. Enter the vehicle and turn the ignition switch to the 'ON' position.
2. (Alarm will sound.)
3. Within 10 seconds push and release the valet switch. The alarm will stop sounding and enter the
disarm mode. You can now start and operate the vehicle normally.
OVERRIDE THE ALARM WITH PASSWORD PIN CODE:
Unlike valet switch that can easily be found and defeated, this security system allows the consumer
to program a password pin code offering a higher level of security.
1. Enter the vehicle and turn the ignition switch to 'ON' position. (Alarm will sound.)
2. Within 5 seconds, enter your chosen first digit code by pressing and releasing the Valet Switch.
(When finished above procedures, system's siren will stop alarming, lights will stop flashing, but
the vehicle can't be started.)
3. Within 15 seconds of the last digit code enter (the 1st code), then turn the Ignition Switch "OFF"
and then "ON".
4. Within 15 seconds, enter your chosen second digit code by pressing and releasing the Valet
Switch.
5. Turn the ignition switch "OFF" position. 4 Chirps from siren/horn and 3 flashes from the parking
light indicate the system has disarmed.
Note: You must override the alarm within 60 seconds. If not, the system will automatically re-arm.
EXAMPLE: To Override the System with the Password Code 83,
1. Enter the vehicle and turn the ignition switch to the 'ON' position.
(Alarm will sound.)
2. Within 5 seconds, Press and Release the Valet Switch 8 times, (When finished the system's siren
will stop alarming, lights stop flashing, but the vehicle cannot be started or driven away.)
3. Within 15 seconds of entering the last digit code enter (the 1
and then "ON".
4. Within 15 seconds, Press and Release the Valet Switch 3 times.
5. Turn the Ignition Switch to the "Off" position. 4 Chirps form siren/horn and 3 flashes from the parking
lights will indicate the system has disarmed.
I.

VALET MODE:

VALET MODE:
(System is in Disarm Mode)
The valet switch allows you to temporarily bypass all alarm function, eliminating the need to hand your
transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm functions
and remote start functions are bypassed, however, the remote panic feature and remote door locks will
remain operational. To use the valet mode, the system must first be disarmed either by using your remote
transmitter, or by operating the Manual Override sequence.
SVMASTER
-
C3 RS915 REV. O1
button a second time within 3 seconds will unlock the other
(Factory Default Setting)
st
code), turn the Ignition Switch "Off"
6
http://www.msvmaster.lv
-
http://www.msvmaster.lv
-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents