Fujitsu fi-60F Getting Started page 18

Symptom
When the document is
scanned in Black &
White mode, the image
generated becomes
black.
Automatic paper size
detection is failed.
Check this item
Are the Document holding pad and
the Document bed of the scanner
clean?
Have you tried to adjust the set-
tings of the scanner driver (Thresh-
old or Brightness)?
Did you scan a document so thin
that the contents of the backside
can be seen through?
Are the Document holding pad and
the Document bed of the scanner
clean?
Did you scan with the document
cover closed?
Is the document rectangular or
square in shape?
Did you scan a document with any
corner folded?
Did you scan a document with
dark-colored edge(s)?
Clean the dirty locations as instructed in the
Operator's Guide "2. Daily Care".
Adjust the Threshold and/or Brightness.
Place a piece of white paper behind the
document and scan again.
- When there are any contents such as
characters on the backside of the docu-
ment, they may be seen through and
appear in the scanned.
- When using "Automatic Size and Skew
detection", place a piece of white paper
of the same size as the document
behind the document.
Clean the dirty locations as instructed in the
Operator's Guide "2. Daily Care".
Close the document cover and scan it
again.
If the document is other than rectangular or
square, the scanner may fail to detect the
size correctly.
Specify the area to scan in the driver set-
ting window manually and scan it again.
If the corner is folded, unfold it.
If the document has dark-colored edge(s),
the scanner may fail to detect the size cor-
rectly.
Specify the area to scan in the driver set-
ting window manually and scan it again.
AP-2
Remedy