Display The Configuration Utility By Using The Default Ip Address - Cisco Small Business AP541N Quick Start Manual

Before You Begin
1. Verify that you have a power source for the Cisco AP541N. If you are
deploying the Cisco AP541N by using PoE, it is necessary to
temporarily power the device by using the provided power supply.
2. Verify that a PC with Microsoft Internet Explorer (version 6 and higher),
Firefox (version 3 or higher), or Safari (for Mac) is available.
Display the Configuration Utility By Using the
Default IP Address
This section describes how to display the Access Point Configuration
Utility by using a PC connected directly to the access point.
192.168.10.10
255.255.255.0
The Cisco AP541N default IP address is required. If the IP address is of the
device is unknown, you can reset the device to factory default parameters
by using the "Returning the Cisco Small Business Pro AP 541N to the
Factory Default Settings"
To configure the access point by using a PC directly connected to the
Cisco AP541N:
Power on the PC and if you have not already done so, configure the
S 1
TEP
PC IP address to an IP address in the same subnetwork. To change
the PC IP address, do the following:
a. From the Windows Start menu, choose Settings > Control
Panel.
b. On the Control Panel dialog box, click Network.
c. In the Network dialog box select TCP/IP for your PC Ethernet
card, then click Properties.
d. In the IP Address window, click Specify an IP address.
4 Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
procedure.
192.168.10.250
255.255.255.0