Table of Contents
Advertisement
HOW TO OPERATE THE TIMER
• After setting of the timer, set the remote controller at a position where the signal can reach the
sensors (indoor unit body) .
(The signal of the timer operation is sent from the remote controller.)
• Set up the timer during display of the operation mode.
Use in the following cases
To stop the air conditioner
after the previously set time
has passed
To stop the air conditioner
every time after the previously
set time has passed
To operate the air conditioner
after the previously set time
has passed
Timer time
Every pushing
, the setup time increases by
0.5 hour (30 minutes).
The maximum time to be set is 72.0 hours.
Every pushing
, the setup time decreases by
0.5 hour (30 minutes).
The minimum time to be set is 0.5 hours.
Timer display
Every pushing
, the display changes as
SET
follows;
ADR
No display
During display
(Ex.) To stop the unit 30 minutes after
1 When pushing the timer
2 Push TIME
3 Push
(Ex.) To stop the air conditioner every time
1 When pushing the timer
2 Push TIME
3 Push
(Ex.) To operate the unit 8 hours after
1 When pushing the timer
2 Push TIME
3 Push
To stop the timer operation
Push
disappears.
8
<Use example>
How to use OFF timer
and the time flash on the remote
controller.
or
to 0.5.
and the
SET
How to use the repeat timer
after 2.5 hours has passed
,
and the time flash on the
remote controller.
or
to 2.5.
and the
SET
timer.
The
works, and the operation stops
after 2.5 hours. When pushing
(Start/Stop) button again to operate the
unit, the operation stops after 2.5 hours.
How to use ON timer
times,
and the timer flash on the
remote controller.
or
to 8.0.
SET
The operation mode display disappears,
and then time and the
To stop the timer operation
button. Then the timer display
C L
once,
SET
to set the time
go on timer.
SET
twice,
to set the time
,
go on
three
SET
to set the time
go on.
Advertisement
Table of Contents
